Edimax SC1000 User manual

SC1000
Quick Installation Guide
07-2014 / v1.0

1
I. Product Information
I-1. Package Contents
1. Security Cover
2. Mounting Bracket
3. Screws
4. Ejector Key
5. Key
6. QIG
1
2
3
4
5
6

2
I-2. Safety Information
The security cover is only for use with the following Edimax products:
-WAP1750
-WAP1200
The security cover should only be mounted to walls –not ceilings. Please note
the following requirements for your security cover’s location:
Do not attempt to fix the security lock to a ceiling or roof.
The security lock is for indoor use only.
1. Do not mount your security cover and WAP1750/1200 directly next to
other electronic devices.
2. Do not mount on uneven, slanted or unstable walls.
3. Do not mount in any location subject to direct sunlight, heat sources or
electromagnetic waves.
4. Do not mount in any location subject to condensation or water.
5. Do not mount in any location with temperatures outside the range 0°C to
50°C.
6. Ensure that your security cover is secured firmly to the wall and installed
according to these instructions.

3
II.Assembly
1. Fix the mounting bracket to the wall using the included screws.
Drill holes and use the included wall-mounting anchors if you
need.
2. Press your WAP1750/1200 (oriented with the antennas at the bottom)
into the bracket and slide downwards to click into position.
Ensure the mounting bracket is positioned
the correct way up, according to the
picture:

4
3. Turn the security cover lock to the “Open” position using the key, and
push the right-side of the security cover into position first. With the right-
side in place, push the left-side down to secure the cover firmly in
position.
4. Turn the lock to “Close” and remove the key.

5
III.Removing the Security Cover
1. To remove the security cover, insert the included ejector key behind the
WAP1750/1200 to unhook the locking clip, as shown below. Slide the
WAP1750/1200 up to remove.

6