Rev: 06142020
Charge 1-2
days before
installing with
switch in OFF
position
5-min walk
test mode
Motion
If
Yes
Light ON
Light OFF No
5 min Daytime?
Light ON Yes Light
OFF
Light turns ON
When
night
comes
Thank you for choosing eLEDing! World’s First AI SMART Lighting:
This innovative AI SMART light is unlike all solar light on the current market without any manually functional setting up, it's able to Auto-
Optimization via AI firmware self-calibration in four seasons and its geographical location. US and international patents granted and pending
worldwide. All rights reserved. Users must read this manual before installation, comply with local standard and regulations of construction &
electrical/electronic projects, follow the safety guidelines to prevent any possible accidents, incident and/or injuries. Consult experienced
contractor/installer and electrical technicians for assistance.
Push
Switch
No
One Step Setup (Just 1 Click!)
Auto convert to
Dimming mode
AI SMART lighting profile
Dimming brightness
until dawn
Dusk to Dawn with
dimming brightness
Full brightness
Up to 3 hours
come to
Max
brightness
The fixed Hours high
brightness period is able
to automatically
adjusted depends on
the multiple factors to
ensure all-night
illumination
In most case, occur
on continuous
cloudy/snowing
days during the
winter season
Motion
detected
Motion
detected
If low power
(20% left)
ON with full
brightness
Motion
Switch to
AUTO Mode
Light OFF
No
Yes
Yes
Full Charge
Back to AI Mode
NO Critical Reserve
(10% left)
ON with half
brightness
Motion
Light OFF
No
Yes
Second stage Intelligence Power Management (IPM) system : monitor & adjust power consumption
AI Mode
In real critical weather
12346 Valley Blvd, El Monte, CA 91732 Phone Number: 1-877-579-3889 Fax: 626-452-9194 Web: www.eleding.com/www.eesgi.com
After Fully
Charged
eLEDing, EE828WAI-2H
AI SMART Solar Light … Built with Dual Ultra-Bright LED Head
Setup
10-3/4”
5-1/2”
Push this latch switch under Sensor head by
a finger, pen or screwdriver to “click” ON
Mount solar panel must
directly facing to Sun always Mount/hanger-on it with screws, Light heads & Sensor adjustability
Installation Guidelines (refer video link: www.eleding.com)
1. Securely mount or even one screw hanger-on the unit on the wall or other surface, etc., adjust the light head direction and sensor angles
based on your need.
2. Solar Panel must be mounted in a non-obstructed position that allows at least 5-6 hours direct sunlight all year round. For most of the North
America projects, adjust the tilt of the solar panel at 25°- 60°degrees based on your actual location. The solar panel can be pointed to between
east and west, but south is the best facing direction and definitely NOT to north. For northern hemisphere installations, a south-facing position
is best and visa-versa for southern hemisphere installation.
Optional AUX 15VDC/<1.5A power sources can be used as back-up power or fast charging source to give the light a quick charge before
installation or for indoor emergency lighting.
3. Solar Panel Maintenance: Use soft, wet cloth to clean the solar panel periodically (at least once a one year) to avoid energy output reduction
resulted from accumulated dust. Clean accumulated snow ASAP during snowing season.
4. Built in Li-poly battery is replaceable
Polycarbonate/PC with Beige color
