Eiki AH-24711 Use and care manual

Projector Lens Replacement Procedure
Model Number
1AA6P1P5754-- (IFRG)
AH-24711/AH-24721/AH-24741/AH-24771/AH-24781
Lens installation and replacement should be made by the qualified
service personnel.
Do not give a shock or excessive load to the projector or the lens
components as the projector and lens components contain precision
parts.
When transporting the projector with the lens, remove the lens before
transporting the projector. The lens and the lens shift mechanism may
be damaged by improper handling during transportation.
Before removing or installing the lens, be sure to turn off the projector,
wait until the cooling fans stop, and turn off the main power switch.
Do not touch the lens surface when removing or installing the lens.
Keep fingerprints, dust or oil off the lens surface. Do not scratch the
lens surface.
Work on a level surface with a soft cloth under it to avoid scratching.
If you remove and store the lens, attach the lens hole cover to the
projector to keep off dust and dirt.
When using the AH-24721 lens unit, set the lens shift adjustment to the
center of the screen. Otherwise, the edges of the screen may become
darker or shadows may appear.
Notes on Lens Replacement
Printed in Japan
●
●
●
●
●
●
●
●
●

-2-
Installing or Removing the Optional Lens
Keep the lens hole cover in safe for later use.
Use the lens hole cover to the projector during
transportation.
Remove the lens hole cover
1
2
Fig-2
Mount the lens
1. Remove the protective caps (front and back) on
the lens.
2. Insert the lens into the lens bracket so that the red
marks on the lens and lens bracket can match.
3. Slowly turn the lens clockwise until it clicks. Make
sure that the lens is fully inserted to the projector.
3Remove the lens LENS RELEASE BUTTON
Fig-3
1. Press and hold the LENS button on the projector
or the LENS SHIFT button on the remote control
for more than 5 seconds to shift the lens to the
center position.
2. Turn off the projector, wait until the cooling fans
stop, and then unplug the AC power cord.
3. Push the lens release button and turn the lens
counter-clockwise and then take it out.
NOTE: Be careful not to drop the lens.
LENS HOLE COVER
Red mark
Fig-1
Turn the projector on and check lens shift, zoom and
focus is operating properly.
NOTE; AH-24721 cannot adjust the zoom.
Confirm of the lens operation