ekwb D-RGB User manual

USER GUIDE
EK-Loop
D-RGB LED Magnetic Strip

Before you start using this product, please follow these basic guidelines:
Carefully read the manual before beginning with the
installation process.
Product should not be used with 12V headers as that will
damage the diodes, they should be powered exclusively by
5V header.

- 3 -
TABLE OF CONTENTS
TEHNICAL SPECIFICATIONS 4
INSTALLING THE D-RGB LED STRIP 5
ATTACHING THE WIRE HARNESS 5
CONNECTING THE LED STRIP 6
SUPPORT AND SERVICE 7
SOCIAL MEDIA 7

- 4 -
TEHNICAL SPECIFICATIONS
- Connection type: 3-pin (+5V, D, Blocked, Ground)
- Rated voltage: 5V DC
- Number of LEDs: 81 (21/strip, 52LED/m density)
- Strip length: 4 x 400 mm
- Strip width: 10 mm
- Cable length: 2x 500 mm, 4x 150 mm wire extender
- Strip thickness: 2.6 – 3 mm
400 mm
50 mm
50 mm
150 mm
500 mm
LED STRIP:
WIRE EXTENDER:
WIRE HARNESS:

- 5 -
INSTALLING THE D-RGB LED STRIP
ATTACHING THE WIRE HARNESS
The EK-Loop D-RGB LED Magnetic strip contains 21 LEDs and
500 mm wire harness. The wire extenders (150 mm) allow you to
connect more LED strips to customize your PC LED lighting (shown
in the image).
The lighting can be attached with magnets or an adhesive strip and
connected via a 3-pin connector to supported 5V D-RGB headers
that are present on most modern motherboards.
Before connecting the LED strip with the motherboard, Wire harness
must be attached as shown in the image.
FEMALE HEADER
FEMALE HEADER
WIRE EXTENDER
LED STRIP
MALE HEADER
MALE HEADER
LED STRIP
WIRE HARNESS

- 6 -
CONNECTING THE LED STRIP
Plug the 3-pin connector of the Wire Harness to the D-RGB HEADER
on the motherboard. The LED will work if the pin layout on the header
is as follows: +5V, Digital, Empty, Ground.
D-RGB HEADER
RGB HEADER

In case you need assistance or wish to order spare parts,
please contact:
https://www.ekwb.com/customer-support/
EKWB d.o.o.
Pod lipami 18
1218 Komenda
Slovenia – EU
SUPPORT AND SERVICE
EKWaterBlocks
@EKWaterBlocks
ekwaterblocks
ekwaterblocks
EKWBofficial
SOCIAL MEDIA