Elite Screens ZRC1-IR User manual

1
Slide
switches
Default
“000”
IR Lens
Led Indicator
light
Up
Stop
Down
Led
Indicator light
Up
Stop
Down
Logo
Logo
FBZZ-RC1Z003-01
Note: IR remote operation requires a
clear line of sight. Assure the IR receiver
is not obstructed.
When operating the screen with the IR
remote, point the “IR Lens/IR LED”
directly to the screen’s “IR receiver”.
ZRC1-IR
IR remote control
ZRC1-RF
RF remote controller
User’s Guide | Infrared (IR), Radio Frequency (RF) and Wall-box controls
Slide switches for RF Code Change
(when multiple RF remotes are owned)
How to change the RF code
1. Remove the batteries
2. Change switch,
3. Insert the batteries
4. Synchronize it with the wall box
(Refer to the Wall-box controller guide for pairing.)
Battery compartment
Requires AAA x 2
(not included)
3.5mm Projector
Trigger Port

2FBZZ-RC1Z003-01
User’s Guide | Infrared (IR), Radio Frequency (RF) and Wall-box controls
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation. Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment. This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.

RJ50: Connects
to the Screen
3.5mm Projector
Trigger Port
3
Led Indicator light
Up
Stop
Down
IR Receiving Window
Programming
Key
Logo
FBZZ-RC1Z003-01
ZRC1-WB Wall-box controller
Programming Key Instructions:
1. How to Preset the Screen’s Drop Position: Drop the screen to the desired position you want to set it at.
Press & hold the “Programming Key”, then press the “down key”.
2. Clear/Reset the Screen’s Drop Position: Press & Hold the “Programming Key”, then press the “stop key”.
3. How to Synchronize/pair a new RF remote: Press & Hold the “Programming Key”, then press the “Up key” on the wall-box (wall-box
LED flashes).
Then press the “Up key” on the RF remote.
The wall-box LED will flash 5 times, to indicate the RF remote has been properly synchronized/paired.