Elo TouchSystems E-Series User manual

Revision B
P/N E134671
www.elotouch.com
Quick Installation Guide
Magnetic Stripe Reader
Elo E-Series AiO Touchcomputer
© 2017 Elo Touch Solutions, Inc. All rights reserved.
The information in this document is subject to change without notice. Elo Touch Solutions, Inc. and its Affiliates (collectively “Elo”) makes no
representations or warranties with respect to the contents herein, and specifically disclaims any implied warranties of merchantability or fitness
for a particular purpose. Elo reserves the right to revise this publication and to make changes from time to time in the content hereof without
obligation of Elo to notify any person of such revisions or changes.
No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any language or
computer language, in any form or by any means, including, but not limited to, electronic, magnetic, optical, chemical, manual, or otherwise
without prior written permission of Elo Touch Solutions, Inc.
Elo (logo) and Elo Touch Solutions are trademarks of Elo and its Affiliates.
North America
800-ELO-TOUCH
Tel [phone]
Fax [phone]
[email protected]
Europe
Tel [phone]
Fax [phone]
[email protected]
Asia-Pacific
Tel [phone]
Fax [phone]
[email protected]
Latin America
Tel [phone]
Fax [phone]
EloSales.LAT[email protected]
Elo Touch Solutions Technical Support
Online self-help:
www.support.elotouch.com

Please go to www.elotouch.com/support to verify you have the latest drivers before installing this device.
Installation
6
5
4
3
2
1Remove access cover “A” and “B”.
Remove all power from the system before installation.
Go to www.elotouch.com/support to download the conguration and demo utility for this device
Remove the two mounting screw
covers on the back of the display.
Secure the MSR to the back of
the display as shown using the
included screws.
Install two new screw covers over
the MSR mounting screws.
Connect the MSR to an available
USB port on the computer I/O
panel and secrure the cable using
the two clips indicated at right.
Reinstall cover “B” and then
cover “A”.
B
B
A
A