Enclume Pr22 Instruction manual

PR22-Oval Pot Rack

Stainless Steel

Enclosed you will find everything needed for the assembly

and use of your storage rack. Two people make assembly

and installation easier. The parts and hardware included are:

Components:

1 – Oval

4 - Hangar arms

1 – Grid

1 – 3/16 Allen wrench

6 – 5/16” x 1/2” Button head screws

Toggle Kit

Hardware:

2 – Ceiling screw hooks

6 – Grid brackets

12 – EPHS SS Pot Hooks

SEE REVERSE SIDE FOR ASSEMBLY AND INSTALLATION INSTRUCTIONS

Thank you for choosing Enclume!

Enclume racks are the ultimate in

quality, design, strength and function.

WARNING: READ ALL OF THE

INSTRUCTIONS BEFORE

ASSEMBLING AND USING YOUR

RACK

If you need help, please call 1-877-ENCLUME

Enclume Design Products

24 Colwell Street, Port Hadlock, WA 98339

Phone 360-385-6100 Fax 360-385-6156

www.enclume.com

Assembly and Installation Instructions:

1) Please proceed carefully through the following instructions to assure this rack is assembly properly for safe installation and

use, and without damage to the finish. Haste in assembly could result in needless scratching or marring of the stainless steel

finish.

2) Notice that each hanger arm has one hole on one end and two different sized holes at the other end. The end of the hanger

arm with the one hole is the end that attaches to the oval. Notice also that two of the hanger arms have a threaded hole at the

end with two holes.

3) Join the two hanger arms with the unthreaded holes to the two hanger arms with the threaded holes by placing a 5/16 x 1/2”

Button head screw through the unthreaded hole through to the threaded hole in each set. Leave the screw loose.

4) Place the oval on a flat surface. Next attach the arm sets to the oval by placing them directly over the mounting holes on the

oval. Make sure the button head screw at the top of the arm sets are both showing from the same side of the rack. Attach

with the four remaining 5/16 x 1/2” button head screws going from the outside of the hanger arms through to the inside of the

oval. Make sure that the arm sets are at right angles to the oval and then tighten all screws using the 3/16 Allen wrench

provided.

5) Place the grid brackets evenly around the oval with the “L” portion of the bracket facing the inside of the rack. Place one

grid bracket at each end of the oval and two grid brackets on each side of the oval.

6) Gently insert the grid through the hanger arms and onto the grid brackets. Assembly is now complete and your PR22 SS is

ready to hang.

7) We recommend that you anchor your rack into the solid wood of ceiling joists or beams. Carefully measure the area where

the rack is to be hung and install the ceiling screw hooks directly into the wood joists. If it is not convenient to hang your

rack directly into wood joists you may use the included DRYWALL anchors enclosed with your rack. See Toggler® brand

manufacturer recommendations for weight limits included in the instructions in the Toggler kit.

It is important that your rack is assembled correctly. If the unit is assembled or used

incorrectly, it could become unstable and collapse, possibly causing injury.

Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Customer's exclusive remedy shall be

the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the warranty

period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St. , Port Hadlock, WA 98339, postage prepaid within 20 days following

a return authorization number (which may be obtained by telephoning the number at the top of this instruction) being provided to the customer by Enclume. There are