Enclume SIGNATURE Series Instruction manual

.
Enclosed you will find everything needed for the assembly
and use of your storage rack. Two people make assembly
and installation easier. The parts and hardware included are:
Hardware included:
2 – Ceiling Screw Hooks
4 – 3/8"x ½"Button Head Screws
8 – 3/8" x 1" Button Head Screws
1 – 7/32"Allen Wrench
1 – Toggle Pack (dry wall anchors)
Components included:
1 – Rectangular Base
4 – Arms
1 – Upper Hanging Rectangle
12 – Angled Pot Hooks
12 – Straight Pot Hooks
4 – L Brackets (Grid Brackets)
1 – Grid
See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS
SIGNATURE SERIES RECTANGLE
SPR2
Thank you for choosing Enclume!
Enclume racks are the ultimate quality,
design, strength and function.
WARNING: READ ALL OF THE
INSTRUCTIONS BEFORE
ASSEMBLING AND USING YOUR
RACK
If you need help, please call 1-877-ENCLUME
Enclume Design Products
24 Colwell Street, Port Hadlock, WA 98339
Phone [phone] Fax [phone]
www.enclume.com

ASSEMBLY AND INSTALLATION INSTRUCTIONS
Rack Assembly
1) Locate the hardware bag containing the button head screws and allen wrench. Place an arm in one of the notches on the wood
side of the rectangle and one of the “L” Brackets (grid brackets) on the inside. Place one of the 3/8"x 1"button head screws in
the arm and with the allen wrench, screw through the arm and the wood anchoring into the “L” bracket leaving the button head
screws a little loose. Repeat for each of the other 3 arms and “L” brackets.
2) Attach the arms to the small hanging rectangle with the button head screws.
3) Square up the rack by aligning the arms so they are perpendicular to the upper and lower rectangles. Tighten all of the button
head screws.
4) Place the grid on the “L” brackets.
5) For your safety, distribute your cookware evenly. Hang your pot hooks from the interior squares only. Do not hang them from
the perimeter or the cut portions of the grid.
Installation:
1) We recommend that you anchor your rack into the solid wood of ceiling joists or beams. Carefully measure the area where
the rack is to be hung and install the ceiling screw hooks directly into the wood joists. If you have a special situation such as
steel joists or masonry, please contact your local hardware store or contractor for expert advice.
2) If it is not convenient to hang your rack directly into wood joists you may use the included DRYWALL anchors enclosed in
the toggle pack included with your rack. Follow Toggler® brand manufacturer recommendations for weight limits included
in the instructions in the Toggler kit.
It is important that your rack is assembled correctly. If the unit is not assembled
correctly or is used improperly, it could become unstable, possibly causing injury.
Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Customer's exclusive remedy shall
be the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the
warranty period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St. , Port Hadlock, WA 98339, postage prepaid within 20
days following a return authorization number (which may be obtained by telephoning the number at the top of this instruction) being provided to the customer by
Enclume. There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING
OUT OF THE PURCHASE OR USE OF ENCLUME'S PRODUCTS.
WARNING