Enclume QR1 Instruction manual

QR1-QUILT RACK
Enclosed you will find everything needed for the assembly
and use of your storage rack. Two people make assembly
and installation easier. The parts and hardware included are:
Hardware included:
6 – 3/8” x ½” Button Head Screws
1 – 7/32” Allen Wrench
Components included:
2 – Upright Supports
2 – Side Cross Supports
2 – Lower Brackets (previously installed)
1 – Top Cross Bar (with curled ends)
See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS
Thank you for choosing Enclume!
Enclume racks are the ultimate quality,
design, strength and function.
WARNING: READ ALL OF THE
INSTRUCTIONS BEFORE
ASSEMBLING AND USING YOUR
RACK
If you need help, please call 1-877-ENCLUME
Enclume Design Products
24 Colwell Street, Port Hadlock, WA 98339
Phone [phone] Fax [phone]
www.enclume.com

ASSEMBLY AND INSTALLATION INSTRUCTIONS
Rack Assembly
1) Place the side cross bars on the inside of the upright supports and attach with four ½” button head screws, going from outside the
upright supports through the side cross bars, so that the heads of the screws show from the outside of the rack. Leave loose.
2) Place the top cross bar underneath the top of the upright supports. Attach the top cross bar by screwing in the remaining two
button head screws from the top of the upright supports through the bottom of the top cross bar.
3) Square up your quilt rack and tighten all button head screws with the hex key provided.
4) Your quilt rack is now fully assembled and ready to display your favorite quilt or blanket.
It is important that your rack is assembled correctly. If the unit is assembled or used
incorrectly, it could become unstable and collapse, possibly causing injury.
WARNING
Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Customer's exclusive remedy
shall be the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within
the warranty period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St., Port Hadlock, WA 98339, postage prepaid within
20 days following a return authorization number (which may be obtained by telephoning the number at the top of this instructions) being provided to the customer
by Enclume. There are no other warranties, expressed or implied. THERE ARE NO WARRANTIES OF MERCHANTABILITY OR FITNESS FOR A
PARTICULAR PURPOSE. ENCLUME SPECIFICALLY DISCLAIMS ANY AND ALL INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING
OUT OF THE PURCHASE OR USE OF ENCLUME'S PRODUCTS.