Eneo DOME-WB1 B User manual

DOME-WB1 B
SPECIFICATION
PARTS SUPPLIED
5mm (Q’ty:1) M6x30mm (Q’ty:4)
M3x12mm (Q’ty:4)
SUS Bushing (Q’ty:4)
Assembly Screw : for main bracket
Mounting Screw : for Pole mount adaptor
DIMENSION
(unit: mm)
Wall Mount Bracket
Installation
Guide
Mounting
Template
L-Wrench
APPLICATION
(PM-42A)
(DOME/BASIS1) (DOME/WEDGE2)
Pole mount adapter :
Mounting on the
pole-like structure
Surface mount or
Tilted mount adaptor
PRIOR to USE
Install the mount onto a strong structure such as concrete
wall. Use the supplied accessories when installing the
mount bracket depends on mounting position.
Mounting Screw
M5x50mm (Q’ty:4)
Plastic Anchor
8x35mm (Q’ty:4) Spring Washer (Q’ty:4)
for Vandalproof dome
M4x12mm (Q’ty:4)
Screwed in Mount-Plate
211
252.7
Ø141.4
108
80
150
183
Aluminum cast
Wall mount for a Vandalproof dome
Ø141.4(W)x183(H)x252.7(L)
1 kg (2.2 lb)
Construction:
Environment:
Dimension(mm):
Weight:
Please Turn Over
M3x8mm (Q’ty:6)
Rear-Plate (Q’ty:1)
Plastic Plate (Q’ty:1)
Cable Grommet (Q’ty:2)
3mm(Q’ty:1)
L-Wrench

INSTALLATION
for Pole mount adaptor
Vandalproof dome
Flush mount unit
Assembly Screw
(M3x12mm)
Mount-Plate
Dome Cover
Surface mount
adaptor
Mounting Screw
(M5x50mm)
Screw (M6x30mm)
with Spring Washer
Bushing
1. Locate the mounting template at the installation position and drill the wall.
2. Remove the release paper of plastic plate and attach to rear plate of the bracket.
3. Route the power and BNC/LAN cables through bracket plates and grommets as illustrated.
4. Place the mount bracket on pre-drilled position and fix it through using mounting screws.
5. Open the dome cover by loosening screws.
6. Affix the surface mount adaptor to the mount plate using the assembly screws (M3x12mm).
Assemble vandalproof dome flushmount unit to the surface mount adaptor.
7. Set the camera’s viewing angle and adjust zoom&focus.
8. Put the dome cover to the dome unit and tighten screws.
Plastic Plate
Release Paper
Rear Plate
Cable
Grommet
* The vandalproof dome and surface mount
adaptor are not included in this package.
eneo® is a registered trademark of VIDEOR E. Hartig GmbH
Exclusive distribution through specialised trade channels only.
VIDEOR E. Hartig GmbH
Carl-Zeiss-Straße 8
63322 Rödermark/Germany
Tel. [phone] / 888-0
Fax [phone] / 888-100
www.videor.com
www.eneo-security.com
Technical changes reserved
© Copyright by VIDEOR E. Hartig GmbH
Version 10/2017