Epson T060120 Operating manual

EPSON
PIS # T060120 Version 3.54 (USA)
Page 1 of 4 Release Date 06/2011
Product Information Sheet
1. Article and Corporate Identification
Product: Epson Ink Cartridge T060120
for use with Epson Stylus C68, C88, C88+, CX3800
CX3810, CX4200, CX4800, CX5800F, and CX7800 Printer
Distributor: Epson America, Inc.
3840 Kilroy Airport Way
Long Beach, CA 90806
United States
TEL: [phone]
FAX: [phone]
The EPSON T060120 Ink Cartridge
2. Composition Information
This is an aqueous ink formulation
Ink Composition CAS No. % By Weight
Carbon Black 1333-86-4 < 5 %
Proprietary dyes and pigments - < 2 %
Proprietary organic materials - 10 –15 %
Glycerols - 10 –15%
Water 7732-18-5 balance
3. Hazard Identification
3.1 Emergency Overview: Ink component is a light black liquid that may cause irritation. Avoid contact with eyes or
clothing. In the case of skin contact, wash with soap and water. Keep out of reach of
children.
3.2 Potential Health Effects:
Eyes: Ink contact with eye may be mildly irritating. See Section 11 for Toxicology.
Skin: Ink contact with skin may cause irritation, swelling, or redness. It is not expected to cause an allergic
skin reaction. See Section 11 for Toxicology.
Inhalation: Intentional exposure to ink vapors may cause respiratory irritation. See Section 11 for Toxicology.
Ingestion: May cause upset stomach. See Section 11 for Toxicology.

EPSON
PIS # T060120 Version 3.54 (USA)
Page 2 of 4 Release Date 06/2011
4. First Aid Measures
4.1 Eyes: Immediately flush with room temperature, low pressure, clean water for at least 15 minutes.Seek
medical attention if eye irritation continues.
4.2 Skin: Wash surface areas with soap and water. Wash soiled clothing before rewearing. Seek medical
attention if irritation continues.
4.3 Inhalation: Remove subject to ventilated fresh air. Consult physician if necessary.
4.4 Ingestion: Seek medical attention if stomach continues to be upset.
5. Fire Fighting Measures
5.1 Flammability: Flash point is greater than 230 deg. F / 110 deg. C (closed cup in accordance with
ASTM D3278)
5.2 Extinguishing Media: Dry chemical or carbon dioxide
5.3 Fire Fighting Instructions: No special fire fighting procedures are required other than breathing apparatus. No
special explosion hazards are known.
6. Accidental Release Measures
If a spill occurs, use sponges to wipe-up ink, then rinse area with damp cloth. Place waste in closed container for
disposal. Use proper ventilation. Do not dispose of waste to the sewer. No eye or skin protection required during
clean-up. Wash hands with soap and water.
7. Precautions for Safe Handling and Use
Keep out of reach of children and do not drink ink. Do not store the cartridge in high or freezing temperatures. Keep
cartridge out of direct sunlight. Do not dismantle cartridge. Do not store cartridges with oxidizing agents or
explosives. Make sure cartridge is dry before insertion into printer housing.
8. Exposure Controls and Personal Protection
8.1 Engineering Controls: None required
8.2 Exposure Controls: None required
8.3 Personal Protection: None required when cartridges are used as intended
9. Physical and Chemical Properties of Ink Formulation
Appearance: Black Liquid
Odor: None
pH: 9.0 – 10.0
Boiling point: Approximately 212 deg. F / 100 deg. C
Freezing point: Less than 32 deg. F / 0 deg. C
Melting point: Less than 32 deg. F / 0 deg. C
Flash point: Greater than 230 deg. F / 110 deg. C (closed cup, ASTM D3278)
Autoflammability: None
Explosive properties: None

EPSON
PIS # T060120 Version 3.54 (USA)
Page 3 of 4 Release Date 06/2011
Oxidizing properties: None
Vapor density: Greater than 1 (air = 1)
Relative density: 1.07 at 68 deg. F / 20 deg. C
Solubility in water: Complete
Solubility in fat: No data available
Partition coefficient: No data available
Viscosity: Less than 5 mPa-s
10. Stability and Reactivity
Stability: Stable
Hazardous polymerization: Will not occur
Hazardous decomposition products: None
Incompatible materials: Oxidizers and explosives
11. Toxicology and Health Hazards
Routes Of Overexposure: Eye, skin, inhalation, and oral
Acute Health Hazards:
•Overexposure of eye surface to ink may be mildly irritating
•Overexposure of skin to ink contact may cause irritation and in some people swelling and redness
•Intentional inhalation overexposure to ink vapors may result in respiratory tract irritation
•Intentional or accidental oral ingestion may cause an upset stomach
Chronic Health Hazards: None known
Carcinogenicity: None known
Toxicity Data: Oral LD50 Dermal LD50 Inhalant LC50 OSHA Regulated?
> 5000mg/kg(Rats) > 2000mg/kg(Rats) Not Applicable Not Established
12. Ecological Information
No data available on the adverse effects of this material on the environment
13. Disposal Considerations
Used and unused cartridges are not a federal RCRA hazardous waste. Disposal should be in accordance with federal,
state, and local requirements.
14. Transportation Information
Not regulated as a Hazardous Material by DOT, IMO, or IATA
15. Regulatory Considerations
U.S. DOT Hazard Class Regulated? NO
U.S. OSHA Inhalation Hazard? NO
In U.S., NFPA/HMIS Hazard Rating: Health (1), Flammability (1), Instability/Reactivity (0), Other (0)

EPSON
PIS # T060120 Version 3.54 (USA)
Page 4 of 4 Release Date 06/2011
16. Other Information
This PIS adheres to U.S. regulatory requirements and standards and may not meet the regulatory requirements in
other locations.
This is a revised Product Information Sheet which replaces all prior U.S. PIS for this product.
This “Product Information Sheet” contains health, safety, and environmental information. It does not replace any
precautionary language or use and disposal information which accompanies the product. The information contained
herein is believed to be accurate at the time of preparation, but should only be used as a guide. EPSON does not warrant
the completeness or accuracy of the information contained herein. It is subject to revision from time to time.
YOU’VE GOT TO SEE IT IN EPSON COLOR™