Epson Stylus SX110 User manual

Printed in XXXXXX
+
+
+
+
User’s Guide
— for use without a computer —
Loading Paper
Copying
Placing an Original
Checking the Ink Cartridges Status
Replacing Ink Cartridges
Enlarging Documents
Documents
Removing and Installing Ink Cartridges
The _mark indicates an expended ink cartridge.
Repeat this step to check other cartridges.
Plain Paper
A4
100
Epson Premium Ink Jet
Plain Paper
80
Epson Bright White Ink
Jet Paper
Loading Capacity
Color
Part numbers
SX110/SX115 TX110/TX111 TX117/TX119
T0891/T0711 91N/73N T0921
T0892/T0712 91N/73N T0922
T0893/T0713 91N/73N T0923
T0894/T0714 91N/73N T0924
Wait about 1.5 min
Cancel
1 2 3 4
6 7
1 2 3
1 2 3
45 6
1 2 3 4
87
9
65
9
5
4 5
Press for three seconds
or
or
Hold ybutton and press xbutton
Draft Document
Flashing quickly On
Open
Close
Open Press
Press
Shake
Remove
Unpack Only remove the yellow tape
8
Install Click
Close
Press
Epson Ink Cartridges
Ink cartridge part numbers vary by location.
For the TX110/TX111, Epson recommends the 91N
cartridges for low print usage.
Scanning
Computer’s scanning software opens
Hold ubutton and press xbutton
20 Sheets

Copyright © 2009 Seiko Epson Corporation. All rights reserved.
1. Nozzle Check
Copy Problems
Close the document cover tightly when you copy.
soft, dry cloth
Turn off
Good printout
Banding
Faint
Colors missing
2. Print Head Cleaning
Bis off, Press for three seconds
Hold down the ybutton and then press the Pbutton
Flashing Wait On
Try 1. Nozzle Check
Lights Cause Solution
&See Loading Paper on the front page.
Prepare a new ink cartridge.
&See Replacing Ink Cartridges on the front page.
If the light is still on or flashing after you replace the cartridge, try the procedure on the right.
Other lights off Sleep mode Press any button except the button to wake the product.
&If the paper is not ejected, try the procedures below.
Turn off
Turn off
All lights flashing Turn off the printer. Open the scanner unit and remove the paper. Then turn the printer back on. If the error does not clear, contact your dealer.
Other lights on Waste ink pad in the printer is saturated. Contact your dealer to replace it.
Troubleshooting
Error Indicators
Problem with printout
&Run a nozzle check
Enlarge