Epson PowerLite 84 System manual

INSTALLATIONHANDBOOK
Lamp and Status Information
Epson PowerLite 84
Replacing the Lamp
The life span of the projection lamp is about 5000 hours if
BrightnessControlin the Setting menu is set to High (default), and
6000 hours if BrightnessControlis set toLow.
It is time to replace the lamp when:
The projected image gets darker or starts to deteriorate.
The message Replace the lamp appears on the screen when the
lamp comes on and the lamp warning light ashes orange. To
maintain projector brightness and image quality, replace the lamp
as soon as possible.
The lamp warning light ashes red (the lamp is burnt out).
Contact your dealer or call Epson at 800-GO-EPSON
(800-463-7766). Request part number V13H010L50.
Replacing the Lamp
1. Turn o the projector.
2. When the Ppower light stops ashing, unplug the power cord.
3. Let the projector cool for at least an hour (if it has been on). The
lamp is extremely hot immediately after use.
4. Loosen the lamp cover screw (you can’t remove it). Then slide the
lamp cover and lift it o of the projector.

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite 84
5. Loosen the two screws holding the lamp in place (you can’t
remove them).
Loosen, but don’t
remove these screws
6. Hold the lamp as shown and pull it straight out.
7. Gently insert the new lamp. (If it doesn’t easily, make sure it is
facing the right way.)
8. Push down the side marked PUSH until it snaps in.
note
The lamp(s) in this
product contain mercury.
Please consult your state and
local regulations regarding
disposal or recycling. Do not
put in the trash.

INSTALLATION HANDBOOK
Lamp and Status Information
Epson PowerLite 84
9. Once the lamp is fully inserted, tighten its screws.
10. Replace the lamp cover, then tighten its screw.
11. Reset the lamp timer as described page.
Resetting the Lamp Timer
After you replace the lamp, you need to reset the lamp timer using the
projector’s menus.
1. Press the
Menubutton on the remote control or on the
projector’s control panel. You see the main menu.
2. Use the buttons on the remote control (or the arrow buttons
on the projector) to highlight Reset, then press Enter.
You see this screen:
3. Select
Reset Lamp Hoursand press Enter.
4. When you see the prompt, select Yes and press Enter.
5. When you’re nished, press Esc or Menuto exit the Menu
system.