Equity 30902 User manual

DIGITAL ALARM CLOCK 12v DC
OPERATING INSTRUCTIONS
Model: 30902
Display / PM Indicator / Alarm On Indicator
When the clock is plugged in, the display 12:00 is being displayed. The clock will automatically indicate AM/PM, but you must be sure to
correctly setthe indicator for the time and alarm. When the PM indictor is on, it is "PM"; when the PM indicator is off, it indicates "AM", When
the Alarm Indicator is on, the alarm will sound at the time set. Once the snooze feature is activated, the alarm indicator will blink.
Set Time
To set the time, press the TIME SET (6) button and the HOUR SET (3) button until the correct hour is displayed (and the AM/PM is correct). then
release the HOUR SET (3) button and press the MINUTE SET (4) button until the correct time is displayed.
Set Alarm
To set the alarm time, press and hold the ALARM SET (5) button and the HOUR SET (3) or MINUTE SET (4) button, as above. Be sure to set the
AM/PM properly too.
Snooze
Touch the SNOOZE bar (1) and getan extra 9minutes to sleep. This may be repeated up to six times within one hour.
To Operate Alarm
Slide the ON/OFF switch (2) on the left of the clock to the ON position. The alarm will sound at the time set.
High /Low alarm sound
Slide the HI/ LO switch (7) on the right of the clock to the Hl or LOW position. The alarm will sound will be higher or lower
accordingly.
Battery Backup (Battery not included)
Install one 9V alkaline battery in the battery compartment using the battery connecter. Note this battery can be installed without disconnectìng
the clock power. If the power fails,the battery backup will automatically continue the time and alarm operation but the display will disappear.
During apower outage, the alarm will sound al the set time. When the power is restored the display digits will reappear with the correct time.
Please help in preservation of the environment and return used batteries to an authorized depot.
Remove the battery from the clock if you do not intend to use for an extended period of time.

Two Year Warranty (U.S.A.)
Equity products are warranted for two years from the date of consumer purchase against defects in material and workmanship.
During this period such defects will be repaired, or the product will be replaced at Equity’s option. This warranty does not cover
damage caused by misuse or negligence. ALL IMPLIED WARRANTIES, INCLUDING BUT NOT LIMITED TO IMPLIED WARRANTIES OR
FITNESS AND MERCHANTABILITY, ARE LIMITED IN DURATION TO A PERIOD ENDING TWO YEARS FROM DATE OF PURCHASE. Some
states do not allow limitations on how long an implied warranty lasts so the above limitation may not apply to you. This warranty
gives you specific legal rights and you may also have other rights which vary from State to State.
If your product is not working properly, please send:
- The Product
- a letter explaining the problem
- and $5.00 for postage and handling to:
Equity Warranty Dept.
2817 Losey Blvd. S
La Crosse, WI 54601
For Customer Support, visit:
www.equitybylacrosse.com/support