Ergotron 20 series User manual

300-5215-00 rev. D • /
01–Caddy Glides...................... Qty. 1 pr..........225-5190-00
02–Keyboard Drawer....................Qty. 1................(see below)
18”W X 11”D (18xx)............ ........................100-6489-xx
20”W X 11”D (20xx)........... ........................100-6359-xx
30”W X 11”D (30xx)........... ........................100-6304-xx
Component list for part #’s 18xx, 20xx & 30xx.
Hello! Thank you for choosing Anthro.
Before beginning installation of your Keyboard Drawer,please take a moment to review the parts listed to verify that
your shipment is complete.
The Cart (shown shaded) is not included with this accessory. An electric drill & 1/8” drill bit may be required to drill the
mounting holes for your Keyboard Drawer. It may also be helpful to review the assembly instructions of all Anthro
products you purchased and are planning to include in this installation.
SAVE THESE INSTRUCTIONS!
Keyboard Drawer
Assembly Instructions
03–3/4”Wood Screws............... Qty. 12 .......... 325-5106-00
04–10-24 X 3/8” Cap Screws...... Qty. 4............. 325-5232-00
05–10-24 Acorn Nuts............... Qty. 4............. 325-5023-00
A 1/8” Hex Key, has been provided to assist you in this assembly.
01
02
03 04
05
Built with Anthro-DNA™

300-5215-00 rev. D • /
Step 3
Pull the Drawer out. Align the two holes on each Bracket
with the predrilled holes on a Shelf. Secure using a total
of eight Wood Screws.
Congratulations! Your assembly is complete.
If your Shelf is not predrilled: place the Keyboard Drawer in the desired location.
Mark all eight holes, then carefully drill using a 1/8”drill bit (3/4” deep). TIP: Place
a small amount of masking tape at 3/4” on your drill bit to guide the hole depth.
Wood Screw Assembled
AnthroCart
Shelf
Pull
Drawer
out
Wood Screw
325-5106-00
Wood Screw
325-5106-00
Cap Screw
325-5232-00
AcornNut
325-5023-00
Cap
Screw
Acorn
Nut Bracket
Step 1
Align a Mounting Bracket with a Glide as shown. Insert
a Pan Screw through the selected hole of the Bracket &
Glide, capturing on the opposite side with a Keps Nut.
Repeat for remaining Brackets & Glides.
Glide
Rubber Bumper
Step 2
Place the Keyboard Drawer between both Glides.
Align the predrilled holes on the Drawer with the holes
on each of the tabs (located on the Glides). Secure using
a total of four Wood Screws.
Wood Screw
Tabs
Curved Edge of
Keyboard Drawer
Tabs
Rubber Bumper
Glide-R
Glide-L
Glide-R
Glide-L
Tabs
© 2018 Ergotron, Inc. All rights reserved.
All trademarks are the property of their respective companies.
Anthro is a registered trademark and brand of Ergotron Inc.
Anthro-DNA is a trademark of Ergotron Inc.
For local customer care phone numbers visit: http://contact.ergotron.com
For Service visit: www.ergotron.com
For Warranty visit: www.ergotron.com/warranty