Ergotron 97-796 StyleView User manual

888-97-284-G-01 rev. C • 04/13
1/5
StyleView® Storage Drawer
User's Guide - English
Guía del usuario - Español
Manuel de l’utilisateur - Français
Gebruikersgids - Nederlands
Benutzerhandbuch - Deutsch
Guida per l’utente - Italiano
Användarhandbok - svenska
ユーザーガイド: 日本語
用户指南 : 汉语
www.ergotron.com
User Guide
12.5"
(315 mm)
10.5"
(267 mm) 10.5"
(267 mm)
3.75"
(96 mm)
2.5"
(64 mm)
or
<0.25 lbs (0.1 kg)< 2 lbs (1 kg)
Total weight capacity per drawer. Total weight capacity per drawer.

888-97-284-G-01 rev. C • 04/13
2/5
A
1
21x 1x
M3 x 22mm
1x
14mm (9/16")
2x
M4 x 12mm
1x 3x or
3x
1x 9x
1 Drawer 3 Drawers
CAUTION: Close worksurface before opening drawers. Open only one drawer at a time. Do Not
push cart when drawers or worksurface are open. Failure to follow these instructions may cause
the cart to be unstable.
WARNING
IMPACT HAZARD!
MOVING PARTS CAN CRUSH AND CUT.
Minimize Lift Tension BEFORE:
· Removing Mounted Equipment.
· Shipping Cart
· Storing Cart
To Minimize Lift Tension
1. Lower worksurface to lowest position.
2. Turn adjustment nut at top of riser
counterclockwise until it stops
(Adjustment mayrequire 40-60 revolutions).
Failure to heed this warning may result in
serious personal injury or property damage!
For More information and instructions refer to product
guide at http://4support.ergotron.comor contact
Ergotron Customer Care at 1-800-888-8458.
822-052
14mm (9/16”)

888-97-284-G-01 rev. C • 04/13
3/5
2
1ab
1x
M3 x 22mm
Slide the drawer onto the bottom tracks of the last drawer.
Attach the Travel
Stop bracket to the
lift engine to keep
the drawer from
hitting the base.

888-97-284-G-01 rev. C • 04/13
4/5
3
4
5
6
2x
M4 x 12mm
To unlock the storage drawer, turn key counter clockwise 1/4 turn.
Remove the
top drawer(s).
Replace the
top drawer(s).
Secure the bottom drawer by
attaching the two screws.

888-97-284-G-01 rev. C • 04/13
5/5
7
14mm (9/16")
Adjustment
It is important that you adjust this product according to the weight of the mounted equipment as described
in the following steps. Any time equipment is added or removed from this product, resulting in a change
in the weight of the mounted load, you should repeat these adjustment steps to ensure safe and optimum
operation.
Adjustments should move smoothly and easily through the full range of motion and stay where you set it. If
adjustments are dicult and do not stay in the desired position, follow the instructions to loosen or tighten
the tension to create a smooth, easy adjustment motion. Depending on your product and the adjustment, it
may take several turns to notice a dierence.
Release Brake to move riser.
Follow these instructions to tighten or loosen tension.
Lift – Up and down
NOTE: Adjustment
may require 40 - 60
revolutions.