ESKUTE Netuno Pro User manual

When open the bike's caon box, take out E-bike and use tools to cut o the package strings.
1.1 Use inner hexagon tool to loosen
the stem cover and dont tighten
all bolts immediately before
adjusting the handlebar in a
propey angel and position.
2.1 Take out the front fork protector
from the front fork( Please note :
Front fork protector is used to
prevent the forks from
beingdeformed during transpo .
It belongs to the packing material .
You can just throwaway this
accesso ! )
2.3 Install the front wheel on the fork .
Make sure the fork is attached to
theaxle and make sure the disc is
placed in the middle of the brake .
2.2 Take out the quick release
from wheel and unscrew
the bolt from the
quickrelease.
2.4 Inse quick-release axle into
spring and tighten screw
Quick releasenut to be at the
same end as the brake.
1.2 Then tighten with tool.
1 Install the Handlebar
2 Install Front Wheel
Netuno Pro Electric Mountain Bike

3 Install the Front Light
Mount the headlight
onthe front fork
bracket with screws.
Check 2 pedals , the
one imprinted L
should install on the
left side andr on
theright side . Please
use a wrench to
tighten them
1 Open the seat post
and saddle , then
install the rear
reector;
2 Adjust seat post to
the height that
suits your riding
position best
andtighten quick release . ( Please make sure
that the quick release is tightenedrmly)
4 install Pedals 5 Install the Seat Post
Each ESKUTE e-bike comes with two copies of the batte key . Charging thebatte on the bike is likely to result in infrequent use of the batte
key however ,is required for maintenance and repair , so please keep this in mind when you stoour Key .
1 Open the box of batte.
2 Tube the batte to correct angle and inse the batte into the holdergently , press it down and lock automatically .
3 Charging the batte outside the bike.
Inse the key to unlock the batte , and then pull the batte upwards.
Remove the batte.
Connect the charger to the batte.
Connect the charger to a power outlet.
The charging process can be stopped at any time.
Disconnect the charger rst from the power outlet and then from the batte.
Replace the batte and make sure it is correctly aligned at the bottom.
Press the top of the batte until you hear a "click" to make sure the batte is properly secured.
Pull the key out.
Your ESKUTE e-bike is ready for use
6 Install Batte
Make sure you always have at least one spare key.
Keep spare keys in a safe place for repairs , maintenance , and emergencies.
Please bring the key with you when you contact your dealer for seice or repair .
7 Range and Speed Selection
To increase the range , we recommend switching to speeds For staing and lowspeed it is better to use a lower gear . At higher speeds , a
higher gear should beselected Redi : e pressure on the pedals during gear shifting for obtainingstable suppo and improved range.
High speed, high gear.
Low speed, low gear.
Reduce pressure on the pedals when shifting gears.
Distributor: Yimei Network Technology Co., Ltd
Website: https://www.eskute.co.uk/
Email: [e-mail]
Manufacturer: Myatu Europe Intelligent Technology Sp.z o.o
Add: Prologis Park Wroclaw 1, building
DC 1 A, Magazynowa 1 street
55-040 Bielany Wroclawskie, Poland
MADE IN POLAND