
Disconnecting the Power/Data Cable
Grasp the cable by the black pro-
tective boot and pull upwards
until the cable is free of the con-
nector.
Note: If you grasp the grey cable
instead of the black protective
boot you could rip the cable as-
sembly apart, always grasp the
cable by the black protective boot!
Reconnecting/Cleaning the Power/Data Cable
Notice the notch in the Display connec-
tor (red arrow). It lines up with the
raised bump on the Cable connector,
opposite the 5 pins. Ensure that the ca-
ble is oriented correctly and then plug it
in and unplug it several times, leaving it
plugged in the last time.
This is to clean the pins and contacts to
ensure a clean flow of Data and Power
to the Remote Display.
Upon reconnection of the cables the Remote Display should flash a 3-digit number, beep and countdown
from 999 to 000, then flash another 3-digit number.
Fast Track 2+2® Remote Display Reset Procedure
ESS, Inc. -- 615-340-9033
Fast Track - Remote Display Reset Page 2