EUCHIPS Walldim 105 User manual

Walldim 105
TRIAC Dimmer
·Support leading edge dimming
·ABS material, high flame retardant
·Fashion, and easy to use
·Can be installed in the wall box
·Suitable for ELV dimming driver, incandescent lamps, halogen lamps and other loads
·Installation in appliance box to DIN 49073 , used in the study, bedroom, restaurant, bars and
other places need dimming control
Product Features
Technical Parameters
Function Description
Wiring Diagram
Caution
(1)Press the knob to switch dimmer.
(2)Adjust the brightness of light by rotating the knob, twist the knob clockwise to brighter
bulb. Dimmer is able to adjust the brightness of bulb from minimum to maximum by
rotary potentiometer.
(3)Press the knob in any state, can open or close the load.
1. Connect the load wire at first, then connect the power wire; Please ensure short circuit can not occur between wires before you turn on the power.
2. Please check the input voltage and frequency range, it may burn out the dimmer once exceed the voltage or frequency range.
1/1
User’s manual: 2019-9 www.euchips.com
Model
Input voltage
Input frequency
Load type
Incandescent lamps: 500W
Halogen lamps: 500W
Dimmable LED: 300W
TRIAC dimming driver: 300W
Ivory-white
86*86*44mm(W*H*D)
103*103*50mm(W*H*D)
140g
-10~40℃
20-90% RH
Panel color
Panel size
Packing size
G.W.
Working temp.
Relative humidity
Walldim105
200-240VAC
50/60Hz
ELV Driver or Other Load
N
L
N
L
LL
500W
230V 50/60Hz
200-240VAC
1. Remove the knob, nut and panel
2. Connect wire according to Wiring Diagram. Refer to Wiring Diagram.
3. Mount the bottom box on the cassette in the wall after connecting the wire, and then
nail the screw, fix it on the wall.
4. Mount panel and knob to the bottom box in the right direction.
Installation Guide
Dimension(mm)

Walldim 105
TRIAC旋钮调光器
·支持前沿调光
·适用于可控硅调光电源，白炽灯,卤素灯等负载
·ABS 高阻燃性材料，耐高温耐冲击
·外形简约时尚，美观大方，操作便捷
·符合 DIN 49073 电气盒，应用于书房，卧室，餐厅，酒吧等需要调光控制的场合
产品特点
技术参数
功能描述
接线图
注意事项
外观及安装尺寸(mm)
安装指南
型号
输入电压
输入频率
负载范围
白炽灯 500W
卤素灯 500W
可调光 LED300W
TRAIC 调光电源 300W
象牙白
86*86*44mm(宽*高*深)
103*103*50mm(宽*高*深)
140g
-10~55℃
20-90% RH
面板颜色
面板尺寸
包装尺寸
毛重
工作温度
相对湿度
Walldim 105
200-240VAC
50/60Hz
1. 按下旋钮可以打开或关断后端负载。
2. 顺时针转动旋钮可调节负载灯的亮度从最小到最大；逆时针转动旋钮可调节负载灯的亮度从最大到最小。
3. 在任意状态下按下开关，都可以开通或关断负载。
1. 接线时，先接负载线，再接电源线。通电前，要确保电路连接正确，防止短路。
2. 输入电压超出面板的电压或频率，可能会导致调光器损坏。
1. 取下旋钮及白色面板。
2. 根据应用接线图进行接线
3. 用螺钉将底盖可靠地安装到墙上的电气盒内。
4. 检查白色面板的方向，将其装在底盖上。
1/1
用户手册: 2019-9 www.euchips.cn
ELV Driver or Other Load
N
L
N
L
LL
500W
230V 50/60Hz
200-240VAC