Euroheat Harmony 1 Operating instructions

1
Euroheat Distributors (H.B.S) Ltd Nov 2004 E & OE Instructions Part Number IN1009 Edition B



(XURKHDW'LVWULEXWRUV
+%6/WG
8QLW&RXUW)DUP
%XVLQHVV3DUN
%LVKRSV)URPH
:RUFHVWHUVKLUH
:5$<
7KHUPLF'LVWULEXWLRQ
(XURSH6$
%)UDVQHVOH]
&RXYLQ
%HOJLXP
Serial Number
Part No.
Lighting, Operating and Maintenace
Instructions for
Harmony 1 Gas Stove

2
Euroheat Distributors (H.B.S) Ltd Nov 2004 E & OE Instructions Part Number IN1009 Edition B



Donotoperatethestovewith itsdooropenorifitsglassisdamaged.



Donotoperatethestoveifthe"coals"aredamagedorarenotas illustrated in the
installationmanual. Donotadd additionalcoalsto thosesupplied withthestove.



Noattemptshouldbe madetoadjust theappearanceoftheflame byadjustingthe
burneror"coals"withoutsuitablegasanalysisequipment.Anychangeintheappearence
ofthe flame pattern shouldbereportedtoyour installer.



Improperinstallation,adjustment,alteration,service,ormaintenancecancauseinjury
orpropertydamage.



Only registeredCORGI engineersareallowed toinstalland maintainthisappliance.



Ensurethis and all other manuals remain with the appliance and are passedtothe
user.



Donot storeorusepetrol orotherflammablevapours andliquidsinthe vicinity ofthis
oranyotherheating appliance.



Thisapplianceisdesignedtobecomehotandshouldbelocatedawayfrompedestrian
traffic,furnitureanddraperies.



Adviseall adults andespeciallychildrento be alerttothehazard of thestove'shigh
surfacetemperatures. Superviseyoungchildrenwhentheyareinthesameroomas
theapplianceand fitasuitablefireguard.



Itis imperative thatallstoveand room ventilation airpassagewaysarekept clear.



Theapplianceshouldbeinspected annuallyby aqualifiedandCORGIregistered
engineer.



Thewarrantyregistrationdocumentmust becompleted bytheinstallerandreturned
withinfourteendays to Euroheat Distributers (H.B.S.) Ltd.
IMPORTANT
READ BEFORE OPERATING THE STOVE
TheGlass
Before attempting to clean your stove’s glass the
stove must be extinguished and allowed to cool, as
for safety reasons it would be foolish to attempt
cleaning whenthestove is operating or stillhot. The
glassin yourstoveisspecially formulatedtowithstand
thevery hightemperaturesgeneratedwithin thestove
andproprietaryglasscleanersarenotrecommended
astheircompositionsmaycontain chemicals that will
weakenoretch into the glass. Newspapermoistened
with water to which a little vinegar has been added
will normally remove most staining.
TheStoveBody
Dusting the stove may be carried out when the stove
isatitsminimum heat output temperature, using light
strokes of a real bristle paint brush. Thorough
cleaning, or any attempt to remove marks on the
stovebody,mustonlybedonewhen the stove is cold.
Stoves with an enamel finish should be cleaned with
a damp cloth, or very gentle use of a cleaner
recommendedforenamelfinishes. It should be noted
thatevenapproved
cleaners will damage the highly polished finish of the
stove if used too vigorously. All traces of the cleaner
must be removed before the stove is lit, and no
finishing polishes must ever be used as these will
leaveunsightlystreaksonthestove when it becomes
hot.
Stoves with a matt cast black finish must never be
cleaned with a cloth as the texture of the paint will
abrade and collect lint from the cloth, which will be
almostimpossibletoremove.Vigorous brushing with
a stiff bristle brush will remove all dust, but where
the paint is marked, the stains are better obliterated
with a spray of suitable stove paint rather than
attempts made to clean them off. Suitable paint may
be purchased from any stove retailer, or direct from
Euroheat.
BrassFittings
Any proprietary brass cleaner may be used to clean
the brass on the stove, but care must be taken to
ensure the polish does not come into contact with
the stove enamel or the black cast finish, where it
will leave a stain.
Cleaning Your Stove

3
Euroheat Distributors (H.B.S) Ltd Nov 2004 E & OE Instructions Part Number IN1009 Edition B
Ignition Sequence
By turning the control dial to alien the "star" symbol
with the index line, gas will be allowed into the pilot
burnerwhen the dial is depressed fullyinto the valve
body. By simultaneouslydepressingthe control dial
and the spark generator button, the pilot burner will
be ignited. The spark generator button can be
released when the pilot flame is observed. (If the
backgroundnoiseof the roomislowitwill be possible
to detect that the clicking sound produced by the
spark will be softened when the gas ignites). The
control dial must be held depressed for twenty
seconds whilst the pilot flame heats the
thermocouple. When the thermocouple heats, it
produces a voltage which informs the valve that the
pilot flame is established and the valve takes over
the supervision of the pilot flame. The control knob
can now be released and the pilot will remain alight.
Main Burner Control
Thermostatic
Whenthegas valve has supervision ofthepilotflame
it will supply gas to the main burner and allow the
main burner to light. The main burner can be ignited
by turning the control dial anticlockwise to any
position up to the position marked "6", the highest
heatsetting. Themain burner will light automatically
from the pilot burner and will burn at a high output
until the temperature setting chosen on the control
dial is reached, the valve will then turn off the burner
or reduce its heat output to one third. The burner
will re-light or its output will increase to meet the
thermostat demands.
Manual
If thermostatic control of the stove needs to be
overridden the control dial should be turned
anticlockwisetoanyposition beyondtheignition"star"
symbol. Themanualcontrol slid from its off position,
indicatedbythewhite dot at the left of thevalvefacia,
and repositioned to give the desired flame size.
Valve Controls
1. The IGNITION BUTTON, positioned at the top of the valve
facia; the button is red and identified with an "electrical flash"
symbol. This button energizes the spark generator when
depressed, producing ignition sparks at one second intervals
for as long as the button is depressed.
2. The CONTROL DIAL,positioned in the middle of the valve
facia; with its setting being indicated by the white line below
the ignition button, has three functions. It turns off all gas
supplies to the stove, it allows the pilot burner to be lit and it
thermostatically controls the main burner.
3. The THERMOSTAT OVERRIDE,the lever positioned at the
bottomof thevalvefacia,sliding fromleftto right,withitssetting
indicated by the symbols directly above it.
Igniter Battery Replacement
Theigniterisenergized byaPP3orequivalent battery.
When it becomes necessary to replace a discharged
battery, itshouldberemoved by liftingitvertically from
its holder and noting the orientation of the terminals.
Ensure the replacement battery has all its protective
packaging and terminal covers removed before
pushing it vertically into the holder.
The minimum and maximum positions correspond
to the width of the white wedge printed above the
slider.Themanualcontrolwillbedisabledifthecontrol
dialisturned to its ignitionsettingandthemain burner
will ignite and burn at the manual override setting
immediately the control dial is turned anticlockwise
from its ignition setting.
Turning Off The Stove
Thestove may beturnedtopilotflame only,byturning
thecontroldial to its ignition position, orextinguished
completely by turning the control knob completely
clockwise to the "off" position indicated with a white
"dot".
Note:- It will not be possible to ignite the stove if
thethermocouple is hot. Ifthestovehasinadvertently
been extinguished or the control dial was released
before the thermocouple was heated sufficiently to
allow the valve to supervise the pilot burner, turn the
control knob to the "off" position and wait for a few
minutes before attempting to light the stove again.
6
4
2
6
4
2

4
Euroheat Distributors (H.B.S) Ltd Nov 2004 E & OE Instructions Part Number IN1009 Edition B
Depress Igniter Button.
Depress Control Dial
for 20 secs.
Set Thermostat Dial position for thermostatic control.
Adjust Manual Override slider for manual control.
Set Control Dial to white dot to turn off.
Lighting The Stove
Switch the manual override to "off".
(White dot)
Control dial to the pilot setting.
(Red star)
OR
6
4
2
6
4
2
6
4
2
6
4
2
Euroheat,Efel andNestorMartin have apolicy of continualresearchand developmentandreserve the
rightto modify its appliances without prior notice.
Wemakeevery effort toensure thattheinformationprovidedin thisdocument iscorrectandaccurateat
thetimeofprinting.Continuedupdatesoccurtoadaptdocumentstocustomerrequirementsandappliance
changes.For the latest editions ofallEuroheat documentation visit our website
www.euroheat.co.uk.
WewouldrequestthatyouinformEuroheatofinformationwhichyoufeelisnotprovidedinthisdocument
whichwouldassistother usersin thefuture.
The Euroheat Technical Team