Eurolec PC TEMP Series User manual
EUROLEC INSTRUMENTATION LTD.
PC TEMP Series
PORTABLE THERMOMETERS
OPERATING INSTRUCTIONS
********************
Battery Fitting
Open the Battery compartment, by removing the screw from the
back of the Instrument and lifting off the cover.
Insert one 9 Volt battery PP3 style (MN 1604 or equivalent), and connect
to the PP3 terminals. It will only fit one way.
Refit the battery compartment cover.
Probe Insertion
Insert the probe plug into the socket at the top of the Instrument,
ensuring correct probe type and polarity observed, by aligning it up
correctly. Also ensure that the plug pins are pushed firmly into the
socket.
NOTE: For safety, do not bring probe into contact with any surface
connected to a hazardous voltage i.e. above 50Volts.
Operation:
Depress the button marked
to turn the Instrument ON and the
button marked
to turn it OFF.
Apply probe tip to substance being measured, and allow reading to
stabilise. This stabilisation time will vary with the different sizes of
probes.
The ⇑and ⇓buttons on the PC Temp K2 model are used to select the
display scale (or resolution). To display temperatures over 200°C the ⇑
button must be pressed.
Press and hold the ON button
to turn on the backlight, when using the
thermometer in a low light area.
There is an auto shut -off facility, which will turn the instrument off
automatically after approx. 5 minutes.
When the battery symbol appears on the display, the battery needs
replacing. No further readings should be taken until a new battery is
fitted.
NOTE: Probes must be handled with care.
•
Always use the probe handle where there is one.
•
Always use the plug to disconnect the probe from the instrument -
never use the cable.
•
Always ensure probes are used for the correct purpose, they should
not be used to bore or lever openings in or between frozen product for
example.
Sensor or cable breakage:
If sensor or probe cable is damaged, the instrument will display
the figure “1” on the left hand side of the display.
Environmental Specification:
Standard instruments are designed to be splash proof (IP64). All
models can be supplied as waterproof (IP67) as an optional extra.
Warranty
This instrument has been carefully assembled and tested, and is
warranted against faulty workmanship and materials for 24 months from
the date of purchase. During the warranty period any defective
instrument will be repaired or replaced at the discretion of the
manufacturer. This warranty does not cover damage or failure resulting
from misuse or accident.
Modification, adjustment or any alteration with the internal arrangement
of the instrument shall absolve the manufacturer from any liability in
respect of the instrument.
Any instrument to be repaired should be forwarded to the
manufacturer, carriage paid and at the owner’s risk. A brief description
of the fault should be included.
********************
Eurolec Instrumentation Ltd.
Technology House, Cluan Enda,
Dundalk, Co. Louth, Ireland.
Tel: +353 (0) 42 9333423 Fax: +353 (0) 42 9331758
www.eurolec-instruments.com
Table of contents
Other Eurolec Thermometer manuals
