Eurolec TH Series User manual
EUROLEC INSTRUMENTATION LTD.
TH SERIES
PORTABLE THERMOMETER
OPERATING INSTRUCTIONS
********************
Battery Fitting
Open the Battery compartment, by removing the two screws
from the bottom of the Instrument and lifting off the cover.
Insert one 9 Volt battery PP3 style (MN 1604 or equivalent), with
terminals facing down. The orientation of the battery is not important; the
instrument will work with the battery fitted either way.
Refit the battery compartment cover.
Probe Insertion
Insert the probe plug into the socket at the top of the Instrument,
ensuring correct probe type and polarity are observed. Also ensure that
the plug pins are pushed firmly into the socket.
NOTE: For safety, do not bring probe into contact with any surface
connected to a hazardous voltage i.e. above 50Volts.
Some probes have sharp points and care must be taken to avoid injury.
Operation:
Depress the button marked
to turn the Instrument ON and the
button marked
to turn it OFF.
Apply probe tip to substance being measured, and allow reading to
stabilise. This stabilisation time will vary with the different sizes of
probes.
When the instrument is on, pressing the
ON button will operate the
backlight facility for low light areas.
There is an auto shut -off facility, which will turn the instrument off
automatically after approx. 3 minutes.
When the battery symbol appears on the display, the battery needs
replacing. Fit new battery before taking any further readings.
If the “Err” message is shown on the display, this indicates that the probe
has been disconnected. It could also indicate that the probe, cable or
plug has been damaged.
NOTE: Probes must be handled with care.
•
Always use the probe handle where there is one.
•
Always use the plug to disconnect the probe from the instrument -
never use the cable.
•
Ensure probes are used for the correct purpose, they should not be
used to bore or lever openings in or between frozen matter for
example.
Environmental Specification:
Standard instruments are designed to be splash proof (IP64). All
models can be supplied as waterproof (IP67) as an optional extra.
Warranty
This instrument has been carefully assembled and tested, and is
warranted against faulty workmanship and materials for 24 months from
the date of purchase.
During the warranty period any defective instrument will be repaired or
replaced at the discretion of the manufacturer. This warranty does not
cover damage or failure resulting from misuse or accident.
Modification, adjustment or any alteration with the internal arrangement
of the instrument shall absolve the manufacturer from any liability in
respect of the instrument.
Any instrument to be repaired should be forwarded to the manufacturer,
carriage paid and at the owner’s risk. A brief description of the fault
should be included.
********************
Eurolec Instrumentation Ltd
.
Technology House, Cluan Enda, Dundalk, Co. Louth, Ireland.
Tel: +353 (0) 42 9333423,
Fax
:
+353 (0) 42 9331758,
email
:
eurolec@esatclear.ie
Please see other Pressure & Temperature instruments on the Eurolec web site
www.eurolec-instruments.com
Table of contents
Other Eurolec Thermometer manuals
