Evantair FH-201 User manual

INSTRUCTION MANUAL
Model: FH-201
AFTER SALES SUPPORT:
AUS 1300 886 649 | NZ 0800 836 761
N13275
FAN HEATER

1
Important Safety Instructions
Please keep this instruction manual in a safe place, along with the purchase receipt and
carton for future reference. The safety precautions enclosed herein reduce the risk of fire,
electric shock and injury when correctly adhered to.
• Do not use the heater unless the feet are correctly attached.
• Ensure the power supply to the socket into which the heater is plugged is in
accordance with the rating label on the heater and that the socket is earthed.
• Keep the power cord away from the hot body of the heater.
• Warning: Do not use this heater in the immediate surroundings of a bath, a shower
or a swimming pool.
• Warning: In order to avoid overheating, do not cover the heater.
• Indoor use only.
• Do not place the heater on carpets having a very deep pile.
• Always ensure that the heater is placed on a firm level surface.
• Do not place the heater close to curtains or furniture in order to avoid a fire hazard.
• Warning: heater must not be located immediately below a socket-outlet.
• Do not insert any object through the heat outlet or air grilles of the heater.
• Do not use the heater in areas where flammable liquids are stored or where
flammable fumes maybe present.
• Always unplug the heater and allow it to cool before moving it from one location to
another.
• Warning: If the supply cord is damaged, it must be replaced by the manufacturer,
its service agent or a similarly qualified person in order to avoid a hazard.
• This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge,
unless they have been given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
• Children should be supervised to ensure that they do not play with the appliance
.
NOTE: Should the unit overheat, this heater is fitted with a safety with overheating
device which will switch the off automatically. (If the air vent is blocked or if
the fan function is not blowing air). If this should happen, all you need to do
is disconnect the plug from the electrical socket for a few minutes. Ensure the
heater is not covered and nothing is obstructing any of the vents. Plug the heater
back into the electrical socket and switch the heater back ON.

2
Operating instructions
Know your Fan Heater
1. Remove the unit from the box and take off any protective wrapping.
2. Place the heater on a smooth level surface and least 30cm away from
any obstacles.
3. Plug your fan heater into the power supply. Make sure your power supply
corresponds to the power indicated on the rating label.
4. Heat temperature setting can be regulated using the switch located on the top of the
heater. This switch is use for both the fan and heat elements. Note the fan speed
cannot be altered and will always remain constant. To turn the application on:
* Fan-for a lower power air circulator; Turn the dial on the right clockwise, once for the
fan function
* Low-Turn it twice for the Medium heat setting (1000W). The setting is best suited for
smaller, well-insulated areas that require less warning.
* High-Turn the switch once more for High setting, or full power (2000W). Which
delivers rapid warm air to increase the temperature to a given area.
Air selection
Cool/Warm/Hot
Adjustable
temperature
Top air grid
Power indicator
light
Front air grid
Base

3
Cleaning instructions
Disposal
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
Do not use any detergents or abrasives and do not allow any water to enter the heater.
Storage
When the heater is not used for long periods of time it should be protected from dust and
stored in a clean dry place.
At the end of its working life, do not throw this appliance out with your household rubbish.
Observe any local regulations regarding the disposal of electrical consumer goods and
dispose of it appropriately for recycling. Contact your local authorities for advice on
recycling facilities in your area.
Distributed by Tempo (Aust) Pty Ltd ABN 70 106 100 252
PO Box 6056 Frenchs Forest LC
Sydney, Australia NSW 2086
Telephone: [phone] Fax: [phone]
Email: [email protected]
Customer Helpline: 1300 88 66 49 (Aust) 0 800 836 761 (NZ)
Overheating Safety Device
Your heater is fitted with a safety device that switches off the heater in the event of
overheating.
Should the heater stop working, turn the heater off and inspect of blockage of inlet or
outlet. Wait at least 5 minutes of the protection system to reset before attempting to
restart the heater.
If the heater fails to operate the safety device switches the heater off again, return the
heater to your nearest service center for examination or repair.