Angle adjustment: To adjust angle, turn base over, rotate leveling foot up
(diagram 6), then push down until locking tabs snap in place. Correct
recline is based on child’s weight; indicator is on side of base (diagram 6).
To store leveling foot, turn over base, pull up on foot, and rotate to stored
position. For installation without base, red arrow on side of carrier must be
level with ground.
Belt path: If LATCH is not in use, secure connectors to
locations provided at side of base (diagram 8). Do not install
using inflatable safety belt.
With base: Vehicle belt is routed under vehicle belt clip in
base (diagram 9). Vehicle belt clip is NOT a lockoff. Lock
retractor and tighten belt. If needed, a locking clip is available
from Evenflo customer service.
Without base: Vehicle lap belt is routed through slots
across top of child’s legs. Shoulder portion of belt, if present, is
placed around back of carrier (diagram 10). If safety belt is not
long enough, shoulder portion may rest against vehicle seat back.
Arrow on side of restraint must be parallel to ground.
LATCH: Remove LATCH connectors by unhooking them from
storage locations on both sides of base (diagrams 8). Attach
connectors to anchors and pull firmly on LATCH pull strap to tighten.
Lower LATCH bars may be used in center seating position when
position is designated as a LATCH location in vehicle owner’s
manual or when distance between bars is between 11 and 20
inches, and vehicle manufacturer permits their use.
Handle: Handle must be locked and must be in position 1 or 3 for use in
vehicle (diagram 11).
Other: When installing this restraint in an outboard seating position,
there should be at least 1.5” of space between restraint, including
handle, and back of front vehicle seat. This guideline is intended to allow
a low safety seat to rotate away from a yielding front seatback in a
severe rear impact.
Seating positions with side air bags may be used if
authorized by vehicle manufacturer.
To remove carrier from base, move handle to
position 1 (diagram 11) and pull up on release handle on
back of restraint.
Use of head or body pillow is optional.
Expiration date can be found on label on seat.
P. 2 of 2
Goodbaby Evenflo LiteMax Sport
7
6
Important: This information sheet is not a substitute for complete manufacturer’s directions and current recall list.
SafetyBeltSafe U.S.A., P.O. Box 553, Altadena CA 91003 (310) 318-5111 (800)745-SAFE ©SafetyBeltSafe U.S.A. #450 10/21
11
8
9
10
9