EverFocus ED700W User manual

M 105-D E100-002
C€ F©
HIGH RESOLUTION
DOME CAMERA
OPERATION MANUAL
Thank you for choosing our high quality camera.
Before attempting to connect operate this unit, please read and follow these instructions.

CONTENTS
1. Caution
2. Feature
3. Package
4. Overview and function
5. In tallation
6. Connection
7. Dimen ion
8. Specification
9. OSD Menu Structure
3

1. CAUTIONS
Thi device complie with Part 15 of the FCC Rule .
Operation i ubject to the following two condition ;
1. This device may not cause harmful interference.
2. This device must accept any interference received, including
interference that may cause undesired operation.
Note
This equipment has een tested and found to comply with limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasona le protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment off and on, the user is encouraged to try to correct the
interference y one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation etween the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio / tv technician for help.
Caution
Any changes or modifications in construction of this device which are not expressly
approved y the party responsi le for compliance could void the user’s authority to
operate the equipment.
A CAUTION
1. A regulated DC12V 1A power supply is recommended for use with this camera
for the est picture and the most sta le operation.
An unregulated power upply can cau e damage to the camera.
When unregulated power upply i applied, product warranty will be out of ubject.
2. It is recommended that the camera is used with a monitor that has a CCTV quality
75 video impedance level.
If your monitor is switched to high impedance then please adjust accordingly.
3. Do not attempt to disassem le the camera to gain access to the internal componets.
Refer servicing to your dealer.
4. Never face the camera towards the sun or any right or reflective light, which may
cause smear on the picture and possi le damage to the CCD.
5. Do not remove the erial ticker for the warranty ervice.
6. Do not expose the camera to rain or other types of liquid.
7. The apparatus must e connected to a mains socket-outlet with a protective earthing
connection.
V ________________________________________
4

1. CAUTIONS
Correct Di po al of Thi Product
(Wa te Electrical & Electronic Equipment)
(Applicable in the European Union and other European countrie with
eparate collection y tem )
This marking shown on the product or its literature, indicate that it should not
e disposed with other household wastes at the end of its working life. To
prevent possi le harm to the environment or human health from uncontrolled
waste disposal, please separate this from other types of wastes and recycle it
responsi ly to promote the sustaina le reuse of material resources.
This product should not e mixed with other commercial wastes purchased this
product, or their local government office, for details of where and how they can
take item for environmentally safe recycling.
Business users should contact their supplier and check the terms and
conditions of the purchase contract.
Household users should contact either the retailer where they for disposal.
A
CAUTION :TO REDUCE THE RISK OF ELECTRIC
SHO CK, DO NOT REM O VE C O VER
(OR BACK). NO USER.SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL
CAUTION
RISK OF ELECTRIC SHOCK DO NOT OPEN A
All
All
Thi ymbol i intended to alert the u er to the pre ence of unin ulated
“dangerou voltage” within the product’ enclo ure that may be of
ufficient magnitude to con titute a ri k of electric hock to per on .
Thi ymbol i intended to alert the u er to the pre ence of
important operating and maintenance( ervicing) in truction in
the literature accompanying the appliance
5

2.Feature
• 1/3" 960H SONY EXview HAD CCD II
• High Re olution of 700TV Line
• OSD Function
• Multi Language
(ENGLISH / JAPANESE / G ERMAN / FRENCH / R USSIAN / PO RTUGUESE / SPANISH / CHINESE)
• 2DNR
• Privacy Zone
• Motion Detect
• DC12V / AC24V Dual Voltage
• ATR(Adaptive Tone-curve Reproduction / Digital WDR)
The function provides gradation compensation to improve the contrast of su jects oth
low-luminance areas and high luminance areas exist in the same picture
• 3-Axi Gimbal
6

3.Package
1 DOME CAMERA
2 VIDEO OUTPUT TEST CABLE 1'
3 OPERATION MANUAL
4 SCREW - 3ea i
5 MOUNT GUIDE y y
7

4.Overview and function
• Name (LED Type)
8

5. In tallation
LED Type
Standard Type
9

6.Connection
• DUAL(DC 12V/AC24V)
DC 12V / AC 24V
• DC 12V
EWhen you install the camera, please glue up the end of ca le to
keep it sta le in order to protect the camera from the humidity pro lems.
10

7.Dimen ion
Unit : mm
0100
11

8.Specification
Signal Format NTSC | PAL
Image Device 1/3"960H SONY EXview HAD CCD II
Scanning System 2:1 Interlace
H.Resolution 700TV Lines
Scanning Frequency H:15.734KHz, V:59.94Hz H:15.625KHz, V:50Hz
Total Pixels 1020(H) X 508(V) 1020(H) X 596(V)
Effective Pixels 976(H) X 494(V) 976(H) X 582(V)
Electronic Shutter Speed 1/60 sec 1/50 sec
S/N Ratio More than 50dB(AGC Off)
Gamma r=0.45
Min. Illumination COLOR : 0.05Lux/F1.2, BW : 0.02 Lux/F1.2
Sync System Internal
Video Output 1.0 Vp-p Composite(75fi)
OSD Built in (Inner Key / Joystick)
BLC OFF / BLC / HLC
White Balance ATW / PUSH / USER1 / USER2 / ANTI CR / MANUAL / PUSH-LOCK
2DNR OFF / ON (Level adjusta le)
ATR OFF / ON (Level adjusta le)
Function MIRROR / BRIGHTNESS / CONTRAST / SHARPNESS / HUE / GAIN
Privacy Masking 4 Zones
Motion Detection 4 Zones
Day & Night AUTO
Language ENGLISH / JAPANESE / GERMAN / FRENCH / RUSSIAN/
PORTUGUESE / SPANISH / CHINESE
Power
Consumption DC12V DC 12 V (±10%) Max.120mA
Dual DC 12V (±10%) Max.150mA , AC 24 V (±10%) Max. 2.3W
Operating Temperature -1 0 ^ ~ + 50^
Storage Temperature -2 0 ^ ~ + 60^
Operating Humidity Less than 80%
Options Dual Power
Weight Approx. 343g
Dimension(mm) 136.4(0) x 95.3(mm)
LED TYPE
Power
Consumption DC12V DC 12V (±10%) Max. 320mA
Dual DC 12V (±10%) Max 390mA , AC 24 V (±10%) Max. 4.8W
Min. Illumination 0 Lux (IR LED ON)
IR LED 850nm, 30ea
IR Beam Range Up to 30M
IR LED Operation On : 1 Lux, Off : 3 Lux
Specifications and designs are su ject to change for improving the functionality of this product without notice
12

9. OSD MENU STRUCTURE
MAIN
MENU 1 t Sub MENU 2nd Sub MENU 3rd Sub MENU 4th Sub MENU
MANUAL TYPE DC
LENS AUTO MODE AUTO,OPEN,CLOSE
SPEED (000 ~ 255)
RETURN
HIGH LUMINANCE MODE SHUT,AUTO IRIS, SHUT+AUTO IRIS
BRIGHTNESS (000 ~ 255)
AUTO LOW LUMINANCE MODE AGC,OFF
BRIGHTNESS x0.2 5,x0.50,x0.75,x1.00
SHUTTER
/ AGC
RETURN
MODE SHUT+AGC
MANUAL SHUTTER 1/50(PAL),1/100(NTSC)
1/60(NTSC),1/120(PAL)
1/2 50,1/500,1/1000
1/2 000,1/4000,1/10000
AGC 6,1 2,18,24,30,36,42,44.8
RETURN
SPEED (000 ~ 255)
DELAY CNT (000 ~ 255)
ATW ATW FRAME x0.50,x1.00,x1.50,x2.00
ENVIRONMENT INDOOR,OUTDOOR
RETURN
PUSH B-GAIN (000 ~ 255)
WHITE USER1 R-GAIN (000 ~ 255)
BAL RETURN
B-GAIN (000 ~ 255)
USER2 R-GAIN (000 ~ 255)
RETURN
ANTI CR
MANUAL LEVEL 24 ~ 103
RETURN
PUSH LOCK
BACK LIGHT OFF,BLC,HLC
MIRROR OFF,ON
BRIGHTNESS (000 ~ 255)
PIC
ADJUST
CONTRAST (000 ~ 255)
SHARPNESS (000 ~ 255)
HUE (000 ~ 255)
GAIN (000 ~ 255)
RETURN LUMINANCE LOW,MID,HIGH
ATR ON CONTRAST LOW,MIDLOW,MID,MIDHIGH,HIGH
RETURN
OFF
*SH UT+ IR IS : Both the Shutter and the Mechanical Iris are automatically adjusted according to rightness.
*Auto Iris(Default): The Shutter stays at the manually selected value and only the Mechanical Iris adjusts to rightness.
13

9. OSD MENU STRUCTURE
MAIN
MENU 1 t Sub MENU 2nd Sub MENU 3rd Sub MENU 4th Sub MENU
MOTION
DET ON
DETECT SENSE (000 ~ 255)
BLOCK DISP OFF,ON,ENABLE (CONTROLER)
MONITOR AREA ON,OFF
AREA SEL
1/4, 2/4, 3/4, 4/4
TOP NTSC:(000 ~ 244) / PAL: (000 ~ 288)
BOTTOM NTSC:(000 ~ 244) / PAL: (000 ~ 288)
LEFT NTSC:(000 ~ 474) / PAL: (000 ~ 468)
RIGHT NTSC:(000 ~ 474) / PAL: (000 ~ 468)
RETURN
OFF
NEXT
EXIT
SAVE ALL
PRIVACY ON
AREA SEL
1/4, 2/4, 3/4, 4/4
TOP NTSC:(000 ~ 244) / PAL: (000 ~ 288)
BOTTOM NTSC:(000 ~ 244) / PAL: (000 ~ 288)
LEFT NTSC:(000 ~ 474) / PAL: (000 ~ 468)
RIGHT NTSC:(000 ~ 474) / PAL: (000 ~ 468)
COLOR (1 ~ 8)
TRANSP 0.00, 0.50, 0.75, 1.00
MOSAIC OFF,ON
RETURN
OFF
NR
NR MODE OFF,Y,C,Y/C
C LEVEL (000 ~ 015)
Y LEVEL (000 ~ 015)
RETURN
CAMERA
ID
ON EDIT MODE
RETURN
OFF
LANGUAGE ENGLISH, a $ S f, DEUTSCH, FRANCAIS, PyccKutf, PORTUGUES, ESPANOL,
CAMERA
RESET
BACK
EXIT
SAVE ALL
'Im po rtant Note :
- Any changes made to the camera settings must e saved prior to exiting the OSD menu.
Else all changes will e discarded
- By changing the lens option in the OSD from MANUAL to AUTO will automatically change the
SHUTTER/AGC setting from AUTO IRIS to SHUT+AUTO IRIS.(Default:AUTO IRIS)
14