Expedition One HI-LIFT/PULL PAL GEN 2 User manual

INSTALLATION GUIDE
GEN 2 TIRE CARRIER HI-LIFT/PULL PAL MOUNT

2
CONTENTS
HARDWARE
ITEM QTY
Hi-Li 1
Hi-Li Pull Pal Plates 3
Hi-Li Knob 2
Hi-Li Knob No read 1
5/16” - 18 X 3/4” Button Head Bolts 2
5/16” - 18 X 1” Carriage Bolt 1
5/16” - 18 Nyloc Nuts 2
3/8”- 16 Clip Nut 2
Linch Pin 1
Top Plate 1
FJ/JK Bottom Plate 1
FJ/JK NATO Mounting Hardware 1
3/8”-16 X 1 1/4” Button Head Bolt 1
3/8”-16 X 2 1/2” Button Head Bolts 2
3/8” Washer 3
3/8”-16 X 1” Nyloc Nuts 3
SKILL LEVEL - 2 STARS
1 STAR EASY - No tools required
2 STARS BASIC - Requires standard tools, basic mechanical knowledge and understanding
3 STARS MODERATE - Requires standard tools. Some drillling and/or cutting.
4 STARS ADVANCED - Requires speciality tools. Drilling, cutting, and/or welding
5 STARS EXPERT - Professional installation recommended.
DISCLAIMER
Expedition One is not responsible for any damages to vehicle or injury.
We always recommend professional assistance when installing our vehicle products.
Always follow safety procautions including the use safety gear and devices.
3
3
1
GEN 2 TIRE CARRIER HI-LIFT PULL PAL MOUNT
MOUNTING PLATES
Place the top and bottom plates as shown.
JK SWING ARM SHOWN  FJ IS MIRRORED
2
FOR USE ON GEN 2 TIRE CARRIER SWING ARMS - FJ CRUISER AND JK WRANGLER
TOP PLATE
FJ JK
HI-LIFT PULL PAL ASSEMBLY
Assemble the Hi-Li Pull Pal
as shown.

4
3
HI-LIFT PULL PAL MOUNTING
Attach the Hi-Li Pull Pal as shown using the provided hardware.
JK SWING ARM SHOWN  FJ IS MIRRORED
3
3/8”-16 X 1 1/4” Button Head Bolt
3/8”-16 X 2 1/2” Button Head Bolts