Faber 630003950 User manual

The Pellicano is an excellent
replacement hood for your
updated pro cooking. Installs
easily to the bottom of your
cabinet.
under cabinet rangehood
updated styling
600 cfm PRO motor
2 halogen lights
3 speed push button controls
dishwasher safe SS grease filters
convertible to recirculating*
New ductless kit available
top or direct rear venting
easy mounting system
sone range: 3.5 - 6.5
6” round duct
°
°
°
°
°
°
°
°
°
°
°
°
30 Stainless
36 Stainless
PELL30SS
PELL36SS
Pellicano
a modern take on the traditional rangehood
Size/Color/Model #
Professional Collection
p.o. box 435 • Wayland, MA 01778 • tel: [phone] • fax: [phone] • e-mail: [e-mail] • www.faberonline.com
* it is highly recommended that
professional style cooking always be
vented to the outside.
FILTER1
Replacement Charcoal Filters
For recirculating installations, high
quality, heavy duty lters ensure
the removal of smoke and odors
from the kitchen.
a
c
c
e
s
s
o
r
i
e
s
For use in make up air environments where
an under 300 cfm hood is required. This
kit reduces the ducting to 5” round and
reduces the cfm to under 300
CFMRED
CFM Reducer Kit
A 4” high stainless steel vent grate which
is installed below the cabinet to recirculate
the air back into the kitchen when
ducting outside is impossible or
impractical. Includes the stainless grate,
installation hardware and charcoal filters
Ductless Vent Grate Kit
30” / DUCTGRT30
36” / DUCTGRT36
Model #
Size / Model #
NEW STAINLESS FILTERS

Dimensional Diagrams & Electrical Knockouts
Rev.07/11
24” minimum
30” suggested maximum
bottom of hood to cooking surface
18” minimum
clearance upper
cabinet to
countertop
36”
70 5/16” minimum
76 5/16” maximum
to bottom of cabinet frame
24” or 30” or 36”
cabinet opening width
Make your ductrun as straight and short as
possible. The ductrun should not exceed 35
equivalent feet if ducted with the required
minimum of 6” round ductwork. Count 45º
angles as 3 feet, 90º elbows as 5 feet, and 90º
at elbows as 12 feet.
For best results, use no more than three 90°
elbows. Make sure that there is a minimum
of 24” of straight duct between elbows if
more than one is used. Do not install two
elbows together. If you must elbow right
away, do it as far away from the hood’s
exhaust opening as possible.
Pre-Planning Your Ductwork -
Important: Consult the installation instructions
before you begin installing this rangehood.
Recirculating Installations
IT IS HIGHLY RECOMMENDED THAT
PROFESSIONAL STYLE COOKING BE
VENTED TO THE OUTSIDE. For installations
where ductwork to the outside of your home
is impossible or highly impractical Charcoal
Filters, which attach to the blower assembly,
absorb smoke and odors.
WARNING! Product specications are subject to change without notication. Consult the installation instructions before you begin installing this rangehood.
Pre-Planning Your Installation - Important: Consult the installation instructions before you begin installing this rangehood.