Fellowes PC 200 User manual

Operating Instructions
Operating Instructions
Operating Instructions
A
B
C
®
Model: PC 200

Equipment Parts
1. Punching Handle
2. Sheet Supporter/Adjustable Coil Guide Selector
3. Adjustable Paper Margin Guide
4. Punching Area
5. Waste Paper Drawer
6. Binding Tray
7. Margin Depth Selector
8. Left Side Cover
9. Punching Handle Cover
Assembly
1. Attach the Punching Handle to the right side of the
machine by firmly pressing square hole of handle
onto square shaft. To operate correctly, the handle
should be positioned as illustrated above.
NOTE: If the handle is not positioned as illustrated
it will not punch. Once handle is fully attached
secure it by inserting the screw supplied.
2. Carefully attach the punching handle cover over
the punching handle.
3. To mount the Sheet Supporter/Adjustable Comb
Guide Selector, first be sure the two (2) phillips
screws are loose enough so the Supporter/Selector
slides easily into place. Mount Supporter/Selector
and secure by tightening screws.
Using the Punching
Machine
Adjusting the Punch
Holes should always be centered between the top and
bottom of paper edge. To center hole, set the
adjustable margin guide. For optimum results, first
use several “practice sheets” to set up margin guide
position.
Determining Coil Size
1. To select the appropriate coil for binding, insert
complete document under “leg” of adjustable coil
guide selector located on the bottom right side.
NOTE: Entire document should fit securely under
“leg” to determine true comb size.
2. Read the corresponding coil size from the center of
the adjustable coil guide selector.
3. Raise adjustable coil guide selector to release
entire document.
4.
OR use chart below.
Choice of Coil
Sheets Coil Size
30 6 mm
45 7 mm
70 10 mm
85 13 mm
120 16 mm
140 18 mm
200 25 mm
Adjustment Margin Depth Selector
After choosing coil diameter, adjust the margin depth
selector according to the following guidelines. Align
number on guide with arrow on machine.
NOTE: The number on the dial should correspond to
the arrow on the cover.
Position Coil Diameter
1 6-14 mm
2 17-22 mm
3 25 mm
A
B
C
®
9
5
1
4
8
3
7
6
2

Punching
Insert all sheets into the punching area. Lower the handle
to punch holes in paper. Return handle to its original
vertical position and remove sheets. Repeat until all sheets
and covers have been punched.
Note: a maximum 20
sheets can be punched at a time.
Binding the Document
1. Align holes. Place punched documents on binding
tray. Starting at the first hole on either end, twist
binding coil until it has passed through every
hole. (Figure A)
2. Close loop by bending end of coil down towards
binding on each end of the document. (Figure B)
Your document is bound.
Emptying Paper Clippings
To remove, simply pull the waste paper drawer out. Its
oversized design means emptying less frequently.
A
B
C
Specifications
Maximum binding length 11 inches (288mm)
Maximum punching capacity (at a time) 20 sheets
Number of punches 43 (disengagable) (4:1 pitch)
Dimensions (L x W x H) 18-7/8” x 18-1/2” x 9-7/8 “ (480 x 460 x 250mm)
Weight 35.5 lbs. (16.2 kg)
Warranty 1 year
Limited Warranty
Fellowes Manufacturing Company warrants all PC Model Binding Machines to be free from defects in material and
workmanship for a period of one year from the date of purchase by the original consumer. The exception to this
are the punching dies which are subject to wear. If any part is found to be defective during the warrant period,
your sole and exclusive remedy will be repair or replacement, at Fellowes’ option and expense, of the defective
part.
This warranty does not apply in cases of abuse, mishandling or unauthorized repair. ANY IMPLIED WARRANTY,
INCLUDING THAT OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, IS HEREBY LIMITED IN
DURATION TO THE APPROPRIATE WARRANTY PERIOD SET FORTH ABOVE. In no event shall Fellowes be liable for
any consequential or incidental damages attributable to this product. This warranty gives you specific legal rights.
You may have other legal rights which vary from state to state. To obtain service under this warranty on
machines purchased in the USA, return the machine prepaid to the address below. Please allow two weeks for
processing.
Return with machine:
• Copy of original sales receipt.
• A card stating your name, address, daytime telephone number, machine model and serial number, plus a brief
description of the problem.
For specific instructions on obtaining service under this warranty on machines purchased outside the USA, contact
the appropriate location listed below.
Warrantor: Fellowes Manufacturing Company
Figure A Figure B

U.S. 1-800-955-0959
Australia + 6139-330-3211 (inside Melbourne)
1-800-331-177 (outside Melbourne)
Benelux + 31-3473-77988
Canada 1-800-665-4339
France + 334-789-12279
Germany + 4951-31-49770
Japan + 81-3-5496-2401
U.K. + 44-1302-885331
Australia Benelux Canada France Germany Italy Japan Poland United Kingdom
Tullamarine, Vic Vianen, NL Markham, Ont. Rennes, I-V Garbsen, Han. Camerano, AN Tokyo Warsaw Doncaster, S. Yorks.
®
1789 Norwood Avenue, Itasca, Illinois 60143-1095 630-893-1600 Customer Service 1-800-945-4545 http://www.fellowes.com
Part No. © 2000 Fellowes Printed in U.S.A.