ferm living Pylo User manual

Assembly manual
Pylo Table Extendable

Box ContentCare Instructions
PLEASE READ BEFORE INSTALLATION
WOOD FURNITURE:
Wood is a natural material – no two pieces of wood are the same – which is why there are no two identical pieces
of wooden furniture. Wood is constantly changing, which means that its structure and colour evolve over time. The
biggest changes occur at the beginning of a piece of furniture’s life. Solid wood is mainly aected by seasonal changes
in humidity. During the summer, wood expands and may cause tabletops to bow slightly. During the winter, the wood
contracts again.
Wood movement – expanding and contracting – can cause ’checks’ (small splits and cracks between the wood’s
veins) to appear. However, these do not damage the product and can usually be treated with a wood oil treatment. To
maximise the lifespan of wooden furniture, it is important to ensure that it is continuously cared for and maintained.
Below are guidelines on how to best treat and maintain your furniture made of solid wood.
Using a neutral wood oil will help the wood retain its original colour, give it a water-repelling eect, and prevent it
from drying out. Apply oil with a soft sponge or soft, lint-free cloth in the direction of the wood grain in a continuous
thin layer. Allow the oil to dry then wipe with a soft, lint-free cloth to remove any excess oil. Daily cleaning (wiping
the surface after a meal, for example) slowly removes oil from the wood, which is why it is recommended that you
treat the wood 4–6 times a year or as needed. Please read the instructions on the bottle before treatment.
For a more thorough clean of your wooden furniture, you should use a wood cleaner, which removes marks like
oil-based stains, water rings and more. It can also be used to wash tannic acid out of oak wood. Remember to treat
the surface with neutral wood oil after using wood cleaner. Always remember to treat the underside of your furniture;
otherwise, there is a risk that the wood will warp or crack. If the surface of the wood ‘rises up’ (becomes rough) after
treatment, you can lightly sand it in the direction of the wood grain using fine sandpaper (minimum 200 grit).
Never use steel wool!
Needed tools
Rubber hammerPhillips head screwdriver Slotted screwdriver
2

F x 4 J x 1G x 1 H x 4
A x 10 D x 4B x 8 E x 4C x 11
Box Content
2
2
2
2
2
2
2
2
1
2
3
4
5
6
7
8
3

1
Assembly Process
4
C
C
4

2
Assembly Process
4
5
A
A
A
G
5

3
Assembly Process
6
7
8
C
C
C
C
C
6

4
Assembly Process
1
H
H
2
H
7

5
Assembly Process
D
D
D
D
1
2
DD
8

6
Assembly Process
C
C
3
C
C
9

7
Assembly Process
3
Groove on the cam head (E)
should face towards the hole.
ATTENTION
E
E
E
E
F
F
3
F
F
10

8
Assembly Process
B
8
B
J
8
1
2
11

9
Assembly Process
67
B
B
B
B
B
B
1
2
12

10
Assembly Process
A
A
1
2
A
13

11
Assembly Process
1
2
3
E
F
14

12
Assembly Process
A
A
G
A
1
2
15

13
Assembly Process
1
2 3 4
16

14
Assembly Process
17

15
Assembly Process
H
H
H
H
18

16
Assembly Process
30
19

fermliving.com