ferm living HAZE FERM-1104263107 User manual

HAZE SIDEBOARD
ASSEMBLY MANUAL

BOX CONTENTS
2 x M6 16 mm screws
1 x hex key 4 mm
1 x cabinet
1 x shelf
1 x u-formed stabiliser
1 x legs
2 x wall-safety set
(M6 16 mm screws x 2)
4 x M8 16 mm screws
1 x hex key 5 mm
2 x rubber pads
1
NEEDED IN ORDER
TO ASSEMBLE
Min. two people Spirit level
2
NB!
Screws and rawlplugs
are not inlcuded, as
dierent kinds of
walls require dierent
rawlplugs/screws.
2 x rawlplugs
2 x screws
The Haze Sideboard is made with thin, powder coated steel plates.
The hinge on the doors are welded to the frame, which means that
adjustment is only possible by regulating the height of the feet.
When mounting the Sideboard, please ensure that the cabinet is
level in all directions by adjusting the height of the feet.
If the doors are not totally aligned, mount the wall bracket accord-
ing to the instruction manual, but please make sure to not tighten
the screws completley. Then push gently on the side of the cabinet
where the door is lower than the other. When the doors are aligned,
tighten the wall brackets completely while still applying pressure to
the side of the cabinet.
Adjust the feet according to the new position of the cabinet.
Before pushing on the side of the cabinet, it is recommended that you
fill it with the items that you have planned to store in it. This is in order
to apply some weight to the cabinet, which can also aect the
alignment of the doors.
Power drill Screw driver Pencil
WARNING

M8 16mm screws
for all 4 corners
Use 5 mm hex key
ASSEMBLY PROCESS
Please mount the cabinet to the legs
using the screws indicated above.
1
ASSEMBLY PROCESS
M6 16 mm screws x 2
Use 4 mm hex key
2
We recommend mounting
the sideboard against a
wall with the incuded
wall safety set.
Mount the wall safety set
onto the sideboard and place
it against the wall. Screw the
wall safety onto the cabinet.
Do not tighten screws yet.
3
Remember to level the sideboard
with the adjustable feet to avoid the
sideboard becoming crooked.
If needed, pre-drill holes
and insert rawlplugs.
Screw the wall safety into
the wall. Finally, tighten the
screws into the cabinet.
3 4

ASSEMBLY PROCESS
Insert the u-formed stabiliser inside the
cabinet so that it faces downwards. Place it
upon the pre-drilled holes at the bottom of
the cabinet, then use the hex key to fasten
the two screws from underneath.
4
2 x M6 16mm screws
Use 4 mm hex key
ASSEMBLY PROCESS
Add the two rubber pads on top of the
u-form to prevent friction between the parts.
Then place the metal shelf inside the cabinet
and lower it down, so that it ends up
resting upon the u-form as well as the
support in the four corners.
5
Add the two
rubber pads
5 6

fermliving.com