ferm living SECTOR SHELVES User manual

SECTOR SHELVES
ASSEMBLY MANUAL  SINGLE & TRIPLE
fermliving.com

ASSEMBLY PROCESSBOX CONTENTS
Start by mounting the
brackets to each shelf.
Two brackets per shelf
and two short screws
for each bracket.
1
SECTOR SHELF
SINGLE - NARROW
SECTOR SHELF
SINGLE - WIDE
x 1
x 4 x 8
x 2
x 2
x 1
x 3
Place the two profiles on
a stable surface, like
the floor or a solid table.
The sides with the large
holes should turn upwards.
Start by attaching the
upper shelf to the profiles
and end with the lowest
shelf. Use the same short
screws as before. Two screws
for each bracket.
SINGLE SHELF: Attach
shelf and continue to step 3.
2
2.a 2.b
2.c
Find a position for
the shelf and hold it
against the wall. Make
sure that it is level. Stick
a pointy pencil/needle
through the holes to
mark the drill holes
on the wall.
3
PLEASE NOTE:
STEP 3 + 4 OF THE
MOUNTING PROCESS
REQUIRES 2 X PEOPLE
90
Remove the shelf from the wall.
Drill the holes and insert rawl-
plugs. Then attach the shelf to
the wall using the long screws.
4
x 4 x 8 x 2
x 2
SECTOR SHELF
TRIPLE - NARROW
The illustration shows triple shelves - but can be followed to assemble single shelves as well.
x 3
x 8
x 3
x 8 x 24 x 6
SECTOR SHELF
TRIPLE - WIDE
x 2
x 2
ADDITIONAL TOOLS NEEDED TO ASSEMBLE THE SHELF
Spirit level
Screwdriver / drill Pencil
x 24 x 6
Please note:
Rawlplugs not
included