NEEDED FOR ASSEMBLING
Min. two people
Spirit level
NEEDED FOR WALL ATTACHMENT
Power drill Screw driver Pencil
WARNING
Screws and rawl plugs for attaching the wall safety sets to the wall are not
included, as dierent types of walls require dierent types of hardware. Please
contact your local hardware store for proper advice on which screws/rawl plugs
to use on your walls. We do not recommend free-standing placement of Haze
Vitrine – do so at own risk.
2. Connect the base and cabinet in all four corners using the
16mm screws and 5mm hex key. Place the two shelves inside
the cabinet.
1. Place the base of the Haze Vitrine against the wall.
Mount the wall safety sets onto the base. Do not fully tighten
the screws yet. Place the cabinet onto the base.
3. Use the adjustable feet to level the Haze Vitrine. Check if
the Vitrine is level using a spirit level. Mount the doors onto
the cabinet.
If the doors do not align at once, try gently pressing the top
corner of the cabinet when the doors are closed. This will indicate
if the legs need to be adjusted lower or higher for the doors to
align. If necessary, re-level the Haze Vitrine by adjusting the
height of the feet. If further adjustment is needed, remove the
door and add one of the included hinge discs to door hinge.
Then, mount the door again.
Screw the wall safety sets into the wall. Finally, tighten the
screws to the cabinet. The Haze Vitrine is now mounted and
ready for use.
CONTENT OF THE BOX
Shelves x 2
Cabinet x 1 Bottom part x 1 Wall safety set x 2
16mm M8 Screws x 4 Hex key 5 mm x 1
Hex key 4 mm x 1
2
M6 x 16 mm screws x 2
Use 4 mm hex key
3
M8 x 16mm screws
for all 4 corners
Use 5 mm hex key
1
4
The Haze Vitrine is made with thin, powder coated steel plates.
The hinge on the doors are welded to the frame, which means that adjust-
ment is only possible by regulating the height of the feet.
When mounting the cabinet, please ensure that it is level in all directions
by adjusting the height of the feet.
If the doors are not totally aligned, mount the wall bracket according to
the instruction manual, but please make sure to not tighten the screws
completley. Then push gently on the side of the cabinet where the door is
lower than the other. When the doors are aligned, tighten the wall brackets
completely while still applying pressure to the side of the cabinet.
Adjust the feet according to the new position of the cabinet.
Before pushing on the side of the cabinet, it is recommended that you
fill it with the items that you have planned to store in it. This is in order
to apply some weight to the cabinet, which can also aect the alignment
of the doors.
