Fernox Total Filter TF1 User manual

TF1 installation and cleaning
Quick Reference Guide
Lid tightening
www.fernox.com
Full instructions enclosed in the TF1 box.
In the event that the lid of the
TF1 filter has been removed,
ensure the lid is fully re-tightened
to the correct position.
Either line-up the yellow arrow
inside the yellow box on the
side of the TF1 (Diagram A)
or align the embossed marks
on the lid (Diagram B), using
the TF1 spanner provided.
Fast clean for TF1 Total Filter & TF1 Compact
– no need to remove lid
30 seconds
Close inlet and
outlet valves
Open outlet and
drain valves
Close drain valve,
replace magnet and
open inlet valve
Remove magnet
1234
The TF1 unit does not need to be disassembled for installation, cleaning or servicing however if disassembled, replace all
appropriate seals for example the lid collar/bleed valve ‘O’ rings, as good practice dictates (spares are provided with product
in box). Additional Fernox TF1 Range Seal and ‘O’ ring kits are available: item number 59288.
A B

Fernox, Forsyth Road, Sheerwater, Woking, Surrey GU21 5RZ
Technical Helpline: [phone] Email: [email protected]
Fernox Total Filter TF1 is UK UK Patent No. GB2448232. Patent Applied For GB1213773.3A
www.fernox.com
Sealed system Open vented system
How to change the orientation of the
TF1 Compact and TF1 Total Filter
Using a flat end screwdriver
in the recess shown, gently
lever the locking clip into
the ‘unlock’ position.
Pull the inlet/outlet port
approximately 3 mm away
from the body to allow
rotation to the required
position.
Push the inlet/outlet port
back towards the body of
the unit to prevent further
rotation.
Push the locking clip
securely back into the
‘lock’ position.
Flow
Flow Return
Return
Best position
Good position
Flow
Flow Return
Return
Best position
Good position