Firesense 60469 User manual

Model #: 604 69

away from flammable liquids and materials.
stable and is placed on a level surface. Follow the above instructions and keep this unit at least
3 feet clear from any objects
Always be careful
when handling this unit, especially around the head of the unit.

Head Post Connect head unit and
base
Head Post
Center Post
Bottom Post
Bottom Post - supports the heater.Electrical
cord runs inside this pole.

Keep flammable
materials, such as furniture, pillows, bedding,
papers cloths, and curtains at least 3 feet
from the heater.
heater
is used near, children or disabled persons.
Always unplug heater when not in use.
Do not operate heater with a damaged cord
or plug. If the heater malfunctions, or has
been dropped or damaged in any manner,
return heater to authorized service facility for
repairs.
Heater can be used indoors or outdoors, but
must be operated at least 3 feet from people
or objects.
Never operate heater near water or where it
can be knocked over.
Do not run cord under carpeting. Do not cover
cord with throw rugs, runners, or similar
coverings. Arrange cord away from traffic area
and where it will not be tripped over.
Connect to properly grounded outlets only.
is used near, children or disabled persons.
4.
5.
6.
7.
8.
9.
is suggested per
operated.
cord
cord
is 0-50 feet, but if a longer cord is reguired use
a 12 gauge longer then 100 feet.

4
Center Post
Bottom Post
Head Post
Base
1
Tilt Switch
2
3
Bracket
Head Post
to the head post. Keep pulling the cord through the bottom of the
affix tilt switch to bracket (diagram, reference 1).
Attach bracket with tilt switch to heating unit (diagram ref.2).
to
to the head post. Keep pulling the cord through the bottom of the
head post,(diagram ref.4).

Take the head post and place the cord down the center of it and into the top of
the center post and through the bottom of the center post and into the bottom post.
Slide the cord all the way down to the bottom of the bottom post and pull it
out the hole on the side of the bottom post.

head post. Keep pulling the cord
circumgyrate the bottom post until the screw into the hole of the base.
Use four screws to concent
one post to another.

Distributed by:
Well Traveled Living, P.O.Box 4,Amelia lsland FL32035
E-mail:[e-mail]
www.wtliving.com
60469

Turn power off,make sure heating head is
not hot. Then put back grill and both panels,screwing on both side covers.

Fire Sense a nd Well Traveled L iving are r egistere d trademar ks of We ll Traveled Imports, lnc . All assembly instruction pr esent ations ar e the property of Well
Tr av el ed Imports, lnc. and are protected by U.S. co py ri gh ts and trademarks. A ll r ights reserved.
RR
R
R