Fisher & Paykel RF201ACJSX1 User manual

Water Dispenser Not Working
Possible Cause What to Do
First use / New Install
Air may be trapped in the line the first time you use it. Press dispenser for two
minutes to remove trapped air and to fill the water system.
Alternatively, this installation may not have been completed correctly, You will
need a Service Technician to assist with this - Click here to schedule a visit.
Water supply – household Check the flow rate of water elsewhere in your household. If it is slow or there
is no water, you may need to contact your water supplier.
Water supply turned off or not
connected
• Turn water on.
• Run your water dispenser pad until water dispenses, this will displace
trapped air in the water tank and filter system. This will take at least 2
minutes. Once water has dispensed reset the dispenser pad for 2 minutes.
Supply line may be blocked.
On first installation there may
be air trapped in water system.
Check supply for kinks or leaks. To remove air, run 3 - 4 litres (4 qt) of water
through the dispenser.
Filter may be blocked and need
replacing Replace filter cartridge, see ‘Water filter’ section in your User Guide.
Dispenser lock turned on
Press the water dispenser lock button
for four seconds until the light turns off.
Frozen water tank Try raising the temperature using the internal control panel at the front of the
fridge section.
https://producthelp.fisherpaykel.com/us/Cool/French_Door/Ice_Only/RF201ACJSX1/Troubleshooting_and_Fault_Codes/Trou…
Updated: Wed, 12 Apr 2023 05:59:16 GMT
Powered by
1

Still Need Help?
You may need assistance from one of our qualified service technicians.
Click on the button below to schedule a visit.
BOOK A SERVICE
or Contact Us
https://producthelp.fisherpaykel.com/us/Cool/French_Door/Ice_Only/RF201ACJSX1/Troubleshooting_and_Fault_Codes/Trou…
Updated: Wed, 12 Apr 2023 05:59:16 GMT
Powered by
2