18
WATER FILTER – ICE & WATER MODELS
All the water supplied to your refrigerator is filtered through a filter cartridge, this helps
remove unwanted impurities and is located behind the kickstrip grille. To maintain water
quality we recommend replacing the filter cartridge every 6 months.
When the filter cartridge requires replacing, the filter change icon will illuminate on
the internal control panel and external display. The icon will flash as a reminder on the
external display whenever water is dispensed.
Replacement filter cartridges (part number: 839041) can be purchased through Fisher &
Paykel Customer Care Centre or online at www.fisherpaykel.com (this service is available
to selected markets only).
IMPORTANT!
To avoid serious illness or death, do not use the water filter where water is unsafe or
of unknown quality.
If the water filtration system has been allowed to freeze, replace the filter cartridge
and flush the water system following the instructions on the previous page.
The water filter cartridge needs to be changed when the filter change icon illuminates
on the internal control panel and external display.
Changing the water filter cartridge
To remove old filter cartridge
1Remove kickstrip grille by inserting fingers into the left
and right square openings on the grille. Pull towards you.
The filter is located on the left-hand side.
2Pull freezer drawer slightly open in order to fit filter
cartridge tool.
3Align the filter cartridge tool to the filter and turn
90°anti-clockwise to loosen, as shown on the right.
4Pull the filter cartridge tool and filter towards you to remove.
– When the filter is removed a few drops of water may
be present. This is quite normal.
– Discard the old filter.
To install new filter cartridge
1Pull freezer drawer slightly open in order to fit filter
cartridge tool. Remove the red protective cap on the
spigot head. Align the filter cartridge tool over the filter.
2Insert the filter cartridge and tool into the bottom left of
the product, as shown on the right.
3Firmly push the cartridge in until the filter head cannot
be pushed any further. Turn 90° clockwise to tighten as
shown on the right.
4Remove filter cartridge tool and close freezer drawer.
Replace kickstrip grille by aligning securing hooks. Push
grille firmly onto product until it clips securely.
5Reset the filter change icon on the display, this will remind
you when the filter next requires replacing. Please refer to
the next page for activation.
6Flush the water filter of any trapped air, harmless carbon
fines and to also check for leaks. Dispense 4litres of water
and discard.
7A few drops of water may appear out of the dispenser over
the next few days as the remaining trapped air is cleared.
Engaging filter cartridge
Disengaging filter cartridge