Flash Furniture WX-5L203-BK-GR-GG User manual

ASSEMBLY INSTRUCTIONS
WX-5L203-BK-GR-GG WX-5L203-WH-GR-GG
Thank you for your purchase!
4 Drawer
Narrow Storage Chest
Before You Begin:
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components
may result.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware
(where included) to help prevent the unit from tipping and causing accidental injury, instability, death
or damage. The tipping restraint is intended only as a safety measure, it is not a substitute for proper adult
supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety
Wall Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Customer Service Email: [email protected] | Phone: [phone]
Online Assembly Instructions: http://ftp.flashfurniture.com/AssemblyInstructions/WX-5L203-X-BK-GR-GG.pdf

PARTS
STEP 2
STEP 3
STEP 1
2pc
1
7pcs
4
5pc
1
①
②
2
A B
1
2
4
1
③
④
⑤
⑥
⑨
4
2
2
4
4
4
⑧
11
⑩
11
64pcs
3
pcs
2
5pcs
1
⑦
⑩
1A
6
6
1B
6
6
3
3
2
7
7
7
2
4
4
4
4
4pcs
4
Wooden top
Adjustable leveler
M6X25mm
M6X10mm
Side frame
STEP 1: Attach Left Frame (Part 1A) and
Right Side Frame (Part 1B) to the Frame Poles
(Part 3) using (4) M6x25mm Screws (Part 6)
Frame Pole
M6x25mm
Hex Wrench
Wooden Top
M6x10mm
Hex Wrench
STEP 2: Place the Wooden
Top (Part 2) with screw holes
facing down and attach to the
frame using (4) M6x10mm
Screws (Part 7)
Wooden Top
Adjustable Leveler
STEP 3: Attach Adjustable Levelers (Part 4) to the
bottom of the frame legs. Turn clockwise to tighten.

STEP 4
STEP 7
STEP 5
STEP 6
9
9
Top: Max static weight capacity 40 lbs.
Drawer: Max weight capacity 5 lbs.
11
⑩
11
⑩
⑩⑩
⑩pcs
4
11
pcs
4
9
8
8
STEP 4: Unfold (4) Fabric Drawers (Part 10) and place Drawer Flooring (Part 11) into the drawer with the pull strap facing up.
Fabric Drawer
Fabric Drawer
STEP 5: Insert drawers into
assembled frame
STEP 6: Insert (2) Wall Anchors (Part 9) into the drywall
Note: A power drill is required to make pre-drilled holes for
wall anchors
STEP 7: Insert Wall Mount Screw
(Part 8) through the hole in the
frame and into the Wall Anchors.