Flash Furniture 801L-LF0005-BK-LEA-GG User manual

Thank you for your purchase!
Customer Service Email: [email protected] | Phone: [phone]
801L-LF0005-BK-LEA-GG / 801L-LF0019-BY-LEA-GG / 802-BRN-GG / 802-GR-GG / 802-IV-GG
Classic Executive
Swivel Office Chair
ASSEMBLY INSTRUCTIONS
Before You Begin:
Please identify all component parts and hardware pieces required before you begin. Carefully remove all of the
components from the packaging and set aside for assembly. Assemble on a soft surface to prevent scratching
during assembly.
Caution:
Tighten all components securely before use. Failure to do so may result in personal injury.
DO NOT use any sharp objects to open plastic wrapped components as damage to product or components may
result. Please align the hole of the triangle bracket with the nut on the side of the back seat cushion. Once
aligned begin install the screws the screws should be able to be turned into the nuts by hand. When the screw is
secured tighten the rest of the screw with a tool.
Warning:
CHOKING HAZARD - Small Parts. Adult Assembly Required.
DO NOT ALLOW CHILDREN TO CLIMB ON FURNITURE
Serious or fatal injuries can occur from furniture tipping over. You must install Tipping Restraint Hardware
(where included) to help prevent the unit from tipping and causing accidental injury, instability, death or damage.
The tipping restraint is intended only as a safety measure, it is not a substitute for proper adult supervision.
To help prevent furniture from tipping over it must be permanently attached to the wall. Anti-Tip Safety Wall
Straps suitable for the unit weight and wall materials (if not included) should be purchased and installed.
Online Assembly Instructions: http://ftp.flashfurniture.com/AssemblyInstructions/802-GR-GG.pdf

PARTS
STEP 1
STEP 2