Flintec CCWR User manual

CC1W
Follow this guide to ensure the system is
properly installed and performing as intended.
Use the indicator lights to check performance,
making adjustments as needed.
Contact support hotline for advice.
Note
Mount the base unit in or near
the control box.
Secure the antenna as high as
possible by utilizing the
extension cable.
Orientate the antenna’s horizontal
edge to face the load cell.
Maintain line-of-sight, if possible.
Note
Mount the load cell, top plate and
washer set as recommended.
Position the front of the load cell

unit.
Connect battery and seal the
door.
Use the indicator lights to verify
the system is working properly
INSTALLATION SUPPORT HOTLINE: [phone]
1
3
56
4
2
Mount the base
unit and antenna
Position the
antenna
Mount the
load cell and
rotate toward
base unit
Connect
the wires
Install the
battery
red
green
white
black
yellow
grey
violet
Vref+
Sig+
Sig-
Vref-
Shield
Position+
Position-
black
yellow
red
Ground
Shield

Installation
Guide




transfered


Link quality
indicator
Comms indicator


Power indicator
power
signal
flintec.com 0099980 v1.0

1Loosen the
three retaining
screws.
x3

Attach the CCWR cable





cell. Tighten

2
CCWR





INSTALLATION SUPPORT HOTLINE: [phone]


flintec.com 0102384 v1.0
4
Pull the CCWR
connector

its length.



on the cable.
3
5Push the remote unit



6

tightening the three
retaining screws.

CCWR





Note
Mount the base unit in or near
the control box.
Secure the antenna as high as

extension cable.



Note




unit.




INSTALLATION SUPPORT HOTLINE: [phone]
1
3
56
4
2
Mount the base

Position the
antenna
Mount the


base unit
Connect
the wires
Install the
battery

green
white

yellow
grey
violet


Sig-



Position-

yellow




Installation








Link quality
indicator
Comms indicator


Power indicator
power
signal
flintec.com 0102384 v1.0