FourStarGroup X2550061 User manual

MODEL: X2550061
BIRD BATH WITH SOLAR LIGHT

PARTS LIST AND ASSEMBLY
IMPORTANCE:
PLEASE READ THE ASSEMBLY INSTRUCTIONS CAREFULLY.
A SCREW DRIVER IS NEEDED DURING THE ASSEMBLY.
MAKE SURE YOU HAVE ALL THE PARTS ON THE LIST.
A: BASE 1 PC B: BOTTOM POLE 1 PC
C: SMALL POOL 1 PC D: MAIN POLE1 PC
E: BIG POOL 1 PC F:SUPPORTING POLE 1 PC
G: TRIPOD 1 PC H:SUPPORTING PANEL 1 PC
I:BARRIER 4 PCS J:BRACE 1 PC
K:ROOF 1 PC L:SOLAR LIGHT 1 PC
M:DISH 1 PC N:MIDDLE BOLT 8PCS
O:MAIN BOLT1PC P:LONG BOLT WITH WASHER 1 PC
Q:SMALL BOLT 3 PCS
Assembly Step:
Please refer to the diagram during assembly.
1. Screw Bottom Pole (B) to the Base (A), then followed by Small Pool (C) and
Main Pole (D).
2. Fix the top of Tripod (G) to Supporting Pole (F) with Long Bolt and Washer
(P), attach the leg of Tripod to Supporting Panel (H) with 3 pcs of Small Bolt
(Q).
3.Place the four pieces of Barrier (I) into position on the Supporting Panel(H).
Connect the Barrier (I) end to end. Fasten the Barrier(I) to the Supporting
Panel(H) with 4 pcs Middle Bolt( N).
4.Now, join Supporting Pole (F) to Big Pool (E) with Main Bolt (O) and screw the
Big Pool (E) to Main Pole (D).
5. Fix the Brace (J) to the pole of Barrier(I) with Small Bolt (Q), then tighten the
Roof (K) to Brace (J). Place the Dish (M) and the Solar light (L) in place. The
assemly of the item is complete.
PART LIST

3

Do you have any questions? Missing small parts or hardware?
If you need assistance with the assembly of your
BIRD BATH WITH SOLAR LIGHT
please e-mail our Customer Service Department at:
[email protected]
or call us at [phone]
or [phone]
Please include the following information in your email:
• Where item was purchased
• Item, model, style or SKU number listed on instructions
or box
• Part number, description of the part and quantity needed
This information will help us get the proper part to you faster
ADDITIONAL INFORMATION FOR SOLAR LIGHT:
The solar light comes with a battery.
Please keep the battery dry.
Please proceed very carefully during the operation.
Please find the following tips to operate the solar light:
1. Counter clockwise turn to unscrew the cap of the light
2. Carefully hold the cap(since the wire inside is limited) and place the
battery in place
3. Horizontal move the on/off switch as shown to turn on/off the light.
4.Put the cap back to its place and turn clockwise to tighten the cap.
Note: Do not overexert during this procedure to avoid the breakage of the
solar light.
Lock
On/Off Switch
Unlock