Franklin 11169 User manual

Assembly Instructions
The net has been designed with red tabs to identify the
top corners and blue tabs to identify the bottom corners.
Follow the numbered sequence to attach the net.
Using the self-stick closure strips, tie the top corners first
which are identified by the two red tabs. Refer to 1 & 2 .
Using the self-stick closure strips, tie the front bottom
corners which are identified by the two blue tabs. Refer
to 3 & 4 .
Stretch the net and using the self-stick closure strips, tie
the back bottom corners. Refer to 5 & 6 .
Attach self-stick closure strips as follows:
4 on the top 7 , 3 on the sides 8 , 2 on the base 9 , and
4 on the base 10 as show.
Franklin Sports Inc.
Stoughton, MA 02072
Made in China
For replacements parts call
1-781-341-5178 or 1-800-225-8649
OR visit www.franklinsports.com
Step
1.
2.
3.
4.
5.
Figure #3 NET ASSEMBLY
BEFORE ASSEMBLY:
NO. 11169
SOCCER GOAL
SIZE: 6ft Wide x 4ft High x 3ft Deep
(1.83m x 1.22m x 91.4cm)
s7ORKONASMOOTHFLATSURFACE
s,AYOUTALLCOMPONENTSSOTHEYAREINEASYREACH
s2EADASSEMBLYINSTRUCTIONSCOMPLETELYTOFAMILIARIZEYOURSELF
with the components.
This goal is designed to provide many hours of enjoyment
if properly assembled and used only for the purpose intended.
Adult supervision is recommended when the goal is used by children.
Adult assembly required.
©2013 MLS, MLS, the MLS logo, Major League Soccer
and MLS team identifications are trademarks and
copyrights of Major League Soccer, L.L.C. All rights reserved.

PART QTY DESCRIPTION
1 2 L Shape Tube 8 1/4in x 37 1/4in (press
button on tapered end)
2 2 L Shape Tube 8 1/4in x 37 1/4in
(perforated end)
3 2 L Shape Tube 8 1/4in x 30in (press
button on tapered end)
4 2 Straight Tube 36in (press button on both
tapered ends)
5 1 Mesh Net 168in x 60in x 4in (4in x 4in)
6 4 U Shape Ground Stake 8in
7 30 Self-Stick Closure Strips 8in x 3/4in
Assembly Instructions
Assemble the first set of tubes as parts 1 & 2 . This will
create the back base.
Insert tapered tubes part 3 to the back base.
Insert tapered tubes part 4 as shown into the upward
reaching section of tubes part 3 .
After assembling the second set of tubes parts 1 & 2 ,
place these on the tapered sections of the tubes part 4 to
complete the frame assembly.
Step
1.
2.
3.
4.
Figure #2
Figure #2A
Assemble all lengths of tubing as shown in Figure #1. Be sure
that the piece is inserted completely. The ends of each tube
insert tightly and are secured when the press button of the tapered
end pops through the adjoining perforated tube. (Refer to Figure #2A.)
FRAME ASSEMBLYFigure #1 FRAME COMPONENTS