Freecom SAF-Z80K2 User manual

Freecom
SAF-Z80K2
DESICCANT DEHUMIDIFIER
OWNERS MANUAL
Please read this manual before operating the unit and retain for future reference.

THANK YOU
THANK YOU VERY MUCH FOR PURCHASING THIS PRODUCT!
Please read the OWNERS MANUAL carefull before operating the unit. This will enable
ou to obtain the ver best result in performance and man ears of trouble free operation
from our unit.
When removing the unit from the packing case, check for shipping damage. Please contact
both shipper and our dealer immediatel if the unit is damaged. All units are carefull
checked before leaving the factor .
IMPORTANT: Please place and operate the unit on even ground all the time.
PRODUCT FEATURES
1. Completel environment-friendl .
Without Compressor and Refrigerant.
2. Light weight and small dimension, onl 6.5 kgs.
3. Low noise operation.
4. Wide temperature using range, from 1℃-40℃.
Unique performance under cold weather.
5. Equipped with heater can remove air humidit rapidl .
6. Automaticall sensing environment to adjust the
most comfortable humidit .
7. Automatic oscillation for even distribution of dr air.
1

PRODUCT DESCRIPTION
A. Operation panel
B. Oscillation louver
C. Air outlet
D. Water indicated window
E. Water tank
F. Handle
G. Air intake grill
H. Air filter
I. Drain hose hole
J. Power cord and plug
3

UNIT SET UP
 Please ensure the unit is placed on even ground.
 Please ensure the unit is a safe distance awa from a wall or furniture.
(See the below graphic)
 Keep the unit a minimum distance of 60cm awa from laundr , in order to prevent
water drop getting into the unit.
4

CONTROL PANEL
POWERFUL
SILENT
NORMAL
5%
FULL TANK
+5%
SET HUMID. MODEAUTO SWING
ON/OFF
12354
SET HUMID.
55%
45%
1. POWER ON/OFF SWITCH BUTTON
This dehumidifier is with AUTO RESTART function after power cut.
Once the power is restored after a power failure, the appliance will restart automaticall .
2. MODE – Fan Speed Setting
This dehumidifier offers ou 3 Modes for our selection. The indicator light will illuminate
when the unit is operating in an of these modes. If the ambient humidit reaches the
desired setting, the indicator will flash, the heater will stop.
When ou turn on the unit b main power, it starts on “NORMAL” MODE.
Press “MODE” to select desired Speed.
Its path c cle should be: NORMAL → SILENT → POWERFUL
NORMAL – Automatic control the fan speed for the most comfortable ambient humidit .
SILENT – Quiet operation with low fan speed, especiall at night.
POWERFUL – Operating with full speed for maximum performance and dr laundr
function.
Restart the unit will be on previous setting.
3. SET HUMID. – Desired ambient humidity setting
Press the button to select desired ambient humidit settings, i.e. around 65%, 55% and
about 45%. The indicator light will illuminate when the unit is operating in an of these
settings.
When ou turn on the unit b main power, it starts on “≈55%” setting. If the ambient
humidit reaches the desired setting, the “MODE” indicator will flash, and the heater will
stop.
Its path c cle should be: "≈55%" → "≈65%" → "≈45%"
5

≈65% – Ambient humidit control at around 65%.
≈55% – Ambient humidit control at around 55%.
≈45% – Ambient humidit control at around 45%.
Restart the unit will be on previous setting.
4. SET HUMID. – Additional humidity setting
Press this button to turn the Additional +5% RH humidit setting ON and OFF. When the
LED is light on, the setting of desired humidit control will plus about 5% at each
humidit setting mode. i.e. "≈65%→70%", "≈55%→60%" and "≈45%→50%"
5. AUTO SWING – AUTOMATIC OSCILLATION
When ou turn on the unit b main power, the oscillation louver will Auto-swing up and
down. Press this button will stop the louver at our desired position. B pressing it again
the oscillation louver will Auto-swing up and down.
Restart the unit will be on previous setting.
WARNING: DO NOT adjust the OSCILLATION LOUVER b hand, as this will cause
damage.
. FULL TANK – FULL TANK INDICATOR
The indicator will flash and the alarm will sound when the water tank is full. Please
empt the water tank and replace it to the proper position, then the unit will running at
previous setting.
7. Ionizer
When ou turn on the unit, the Anion generator will ON b a 30 seconds dela -time, the
unit will releases negative ions from air outlet. and it will simultaneousl OFF while the
unit turn off.
6

OPERATING PROCEDURE
 Ensure the unit is placed on even ground.
WARNING:
 Once ou turn off the unit, the oscillation louver will swing back to the level. The fan will
keep running about 2 minutes to release heat.
 DO NOT unplug from the mains till the fan is off.
2. Press the MODE control to select the desired performance.
3. Press AUTO SWING to control the air delivered direction.
4. Set the TIMER, if required.
HOW TO EMPTY THE WATER TANK
1. Gentl pull out the water tank and
lift it b the handle.
2. Open the sliding which on the left
side of the tank cover.
3. Pour water out. Clean the tank with
water if necessar . Do not use an
chemical solvent to clean it.
4. Slide back the opening and press
back the handle in its original place.
5. Replace the water tank into the unit.
7

CONTINUOUS DRAINAGE
In certain situations it ma be more convenient to set the unit up for continuous drainage. A
hose with an inner diameter of approximatel 10-10.5mm is required (not supplied). A t pical
reinforced section of a garden hose would be suitable.
1. Ensure the unit is off.
2. Cut out the outlet at the back of the unit with a screwdriver.
3. Pull out the water tank and remove the rubber bung from the water
outlet at the back of the water tank.
4. Pull through the hose and connect to the outlet on the tank.
Retain the rubber bung for future use.
5. Push the tank back into the unit ensuring the hose sta s
connected to the outlet. Make sure the tank is right position.
CAUTION:
If ou wish to revert back to draining into the tank, when the unit is switched off and
unplugged, simpl remove the drainage hose. Pull out the tank and replace the rubber bung
in the water outlet and push the water tank securel into place.
WARNING:
Please note that this appliance uses a gravit drain when on continuous drain. The hose
must be directed in a downward position.
8

MAINTENANCE
 Alwa s remove the plug from the power socket before carr ing out an cleaning or
maintenance operations.
CLEANING THE CABINET
Clean the cabinet with a soft damp cloth.
NEVER use harmful chemical products or
polish on the unit, as these solvents ma
serious damage the plastic surface.
WARNING:
DO NOT spra water or an solvents on the unit, as this ma damage the electrical
insulation.
CLEANING THE AIR FILTER
 Clean the air filter ever two weeks.
If dust and dirt are allowed to accumulate
on the filter, this will reduce the
performance of the dehumidifier.
 Carefull pull out the filter screens
from the unit.
 You can use a vacuum cleaner. If the filter
is ver dirt , it ma be washed with a mild
detergent in warm water.
CAUTION: Ensure that the filter is dr before replacing. Never operate unit without filter,
as this will reduce the efficienc of the unit.
LONG-TERM STORAGE
The following procedures are recommended for long-term storage:
1. Turn off the unit and remove plug from mains after the fan completel stops.
2. Carefull pull out and empt the water tank.
3. Wrap power cord and secure with cord wrap on back of unit.
4. Clean the air filter and plastic cabinet.
5. Cover unit with plastic bag to protect it from dust.
6. Store the unit in its upright position awa from sunshine in a cool dr place.
9