Freescale Semiconductor NXP 56F8014 User manual

© Freescale Semiconductor, Inc., 2005. All rights reserved.
CPA56F8014KIG
Rev. 0, 04/2005
Freescale Semiconductor
56F8014 Socket Board for Flash Programming
Kit Installation Guide
Welcome!
Thank you for choosing this Freescale Development Tools product. This document
provides instructions on how to set up the Freescale 56F8014 Socket Board.If you
have any questions regarding the hardware kit or software development tools,
please contact the Technical Information Center:
www.freescale.com/support
Kit Contents
Your 56F8014 Socket Board kit includes:
Hardware
• 56F8014 Socket Board (CPA56F8014)
Documentation
•56F8014 Socket Board for Flash Programming Kit Installation Guide (this
document)
• Warranty Registration card
• NOT included in kit:
56F8014 Socket Board User Guide (56F8014SBUG); see
www.freescale.com
System Requirements
• 56F8014 Demonstration Board
(DEMO56F8014 or DEMO56F8014-E)
• CodeWarrior Development tools with
Processor Expert
TM
Help
To obtain assistance for the 56F8014
Socket Board, please contact the Technical
Information Center:
www.freescale.com/support
1
Install the 56F8014 Socket Board and the 56F8014 Demonstration Board
1. Remove all power connections from the demo board and the socket daughter card.
2. Connect the 56F8014 Socket Board to the 56F8014 Demonstration Board via the 40-pin expansion connector.
• Align pin 1 from the 56F8014 Socket Board expansion connector with pin 1 of the 56F8014 Demonstration Board expansion
connector as shown.

metrowerksTM
www.metrowerks.com
CodeWarrior, Metrowerks and the Metrowerks logo are registered trademarks of Metrowerks, Inc. Freescale and the Freescale logo are registered trademarks of Freescale Semiconductor, Inc.
All other companies and products may be trademarks of their respective owners and are hereby recognized.
Flash Programming
3
1. Place the 56F8014 device into the appropriate socket.
2. Use CodeWarrior tools to download your application into the 56F8014 Flash memory.
Connect the 56F8014 Socket Board and the
56F8014 Demonstration Board to Your Computer
2
1. Plug the power supply into the power jack on the 56F8014 Demonstration Board.
2. Plug the +9V DC power supply into an AC outlet.
3. Connect the JTAG adapter between your computer and the 56F8014 Socket Board.
4. Install CodeWarrior tools (follow the instructions included in the DEMO56F8014 kit).