Freewing Li P.15 Diana User manual

www.sz-freewing.com
EN 1~7
中8~14
U S E R M A N UA L

1
Introduction
Basic Product Information
Package List
PNP Install Insturctions
Install Main Wing
Install Vertical Stabilizer
Install Antenna
Pushrod instructions
Battery Size
Center of Gravity
Control Direction Test
Dual Rates and Flight Attention
Accessories Description
Motor Specifications
Motor Overview
Accessories Introduction
Servos Introductions
Install nose landing gear
lnstall rear landing gear
Item No.:FJ110
Catalog
1
2
2
3
3
3
3
4
4
5
5
6
6
6
7
7

2
1
2
3
4
PNP ARF Plus Airframe PNP Airframe
5
6
7
8
ARF Plus
Standard version
2
Wing Loading: 50g/dm
2
WingArea：8 dm
Motor: 2627-4500KV
Brushless Outrunner Motor
Ducted fan: 64mm 5-Blade Fan
ESC: 30A Brushless
Servo: 9g Plastic Servo(2pcs)
Top Speed : 160KPH/100MPH
Empty Weight:260g(without battery)
Bench Tested Thrust: 750g
Landing gear: fixed landing gear
(Optional spare part, need to purchase separately.)
750mm(29.5")
495mm(19.5")
Item No.:FJ110
Product Overview
,
The package don t include the landing gear, if you need,please contact your local dealer.
Package List
No. Name NameNo.
Antenna
Carbon tube
Glue
User Manual

Install Main Wing
3
Step 2
Step 1
As shown in this photo:
1.Insert the carbon tube into the fuselage and keep
it in the center.
2.As the right photo show, use glue to install the
main wing on the fuselage.
Carbon tube
(Ø4x320mmmm)
1.Use glue to attach the vertical stabilizer on the fuselage as the
below photo shown.
67.8mm
(3-1/16")
Pushrod diameter Ø1.2mm 1
2
3
2
3
1
Antenna
Item No.: FJ110
PNP lnstallation Instructions
Fuselage
Main wing
Install Vertical Stabilizer
Vertical stabilizer
Install Antenna
Pushrod Instructions
Aileron pushrod mounting hole
Aileron pushrod size

4
Battery cabin size:
L=110 W=46 H=43(mm)
Battery
58mm
(2-5/16")
Item No.:FJ110
PNP lnstallation Instructions
Battery Size
Use rubberized non-slip tape
or hook-and-loop tape
Center of Gravity
Correct Center of Gravity ( CG”) is critical for the aircraft to fly safely and in control. ”
Please refer to the following CG diagram to adjust your plane’s Center of Gravity.
- You can move the battery forward or backward to adjust the Center of
Gravity.
- If you cannot obtain the recommended CG
by moving the battery to a suitable location,
you can also install a counterweight to achieve
correct CG. However, with the recommended
battery size,no counterweight is required. We
recommend not flying with a battery size that
requires a counterweight.
”
Cockpit
Pull the latch back
and open the cockpit.
Battery tray Velcro
We recommend the following LiPo battery:
3S 11.1V 1000mAh ~ 3S 11.1V 1600mAh
>
Discharge rate of C 30C
Before connecting the battery and receiver, please
switch on the transmitter power and make sure
the throttle stick is in the lowest position. Bind your
receiver to your transmitter according to your
transmitter’s instruction manual.

Control Direction Test
5
H1
H2
H1
H2
H1/H2 11mm/11mm
D/R Rate：60%
H1/H2 15mm/15mm
D/R Rate：80%
H1/H2 15mm/15mm
D/R Rate：80%
H1/H2 20mm/20mm
D/R Rate：100%
Item No.:FJ110
Dual Rates
According to our testing experience, use the following parameters to set Aileron/Elevator Rate.
Program your preferred Exponential % in your radio transmitter. We recommend using High Rate for the
first flight, and switching to Low Rate if you desire a lower sensitivity. On successive flights, adjust the
Rates and Expo to suit your preference.
升降舵
Stick Down Stick Up
PNP lnstallation Instructions
Aileron Elevator
Aileron(measured closest
to the fuselage)
Elevator(measured closest
to the fuselage)
Low Rate
High Rate
Flight attention: When full throttl to fly, the nose will be down. please set up 1.5mm elevator up to avoid the nose down
phenomenon and maintian its in the same level.

6
1 2
2627-4500kv
Item No.:MO026272
2627-4500
11.1 28 750 49000 50E72011 310 2.4
64mm
5-blade EDF
Weight
(g)
Power system
No. Thrust(g)
Current(A)
Use voltage
(V)
Max power
(W)
Efficiency
(g/w)
EDF Fans
Motor
Specifications
（KV）
Rotating speed
(rpm)
Uni:mm
A
B
C
D
E
F
G
平 尾 组 装
Step 1Step 2Step 3
AB
C
D
Refer to the following photo to install ESC and power system
A- ESC
B- 64mm EDF power system
C- EDF cover
D- Screw (PA2.3x16 2pcs)
Item No.:FJ110
Motor Specifications
Accessories Description
A-
B-
C-
D-
E-
F-
G-
Motor 2627-4500KV
64mm Outrunner ducted frame
Screw (PM2.5x6 2pcs)
Motor collet
Motor collet backplate
64mm 5-blade ducted fan
Nut
Motor Overview
Standard version
Note: When the ESC and battery are connected, avoid touching
the ESC by hand to avoid accidental injury due to heat When testing the
EDF, please use safety test stand for testing.Never hold an EDF unit in
your hand while it is powered on.
Servos Introductions
Main wing(L)
Main wing(R)
1
2
Positive
Positive
300mm
300mm
9g plastic servo
9g plastic servo
Servo regulation Pos./Rev. Cable length
Position No.
If you need to purchase another brand’s servo, please
refer to the following list to choose a suitable servo.
Accessories Introduction

Spare part name and parameters
A -
B -
C-
D-
E -
F -
G-
H-
I -
J -
K -
Servo fixed mount
9g Servo
Screw (PWA2.3x8 1pcs)
Set screw (M3x3 4pcs)
Nose wheel strut fixed piece
Nose wheel strut (top)
Wheel connecting part
Nose wheel strut (bottom)
Nose wheel (Ø35x10mm)
Wheel chock
Nose landing gear
7
Step 1
A
B
C
E
F
D
Step 2
G
H
J
D1
D2
D3
I
Step 3
K
A-
B-
C-
D-
E-
F -
Main landing gear fixed mount
Rear gear main strut
(Ø50x15mm)Nose wheel
Wheel chock
(M3x3)Set screw
Main landing gear door
Step 1
ABC
D
EStep 2
F
Item No.:FJ110
Landing Gear Assemble
Landing gear is the optional part, please consult with the local distributor to purchase, and refer to the
following instructions to install.
Install nose landing gear
Please refer to the following photo for assembly and installation of the landing gear.
Install rear landing gear
Please refer to the following photo for assembly and installation
of the landing gear.
Spare part name and parameters
Attention: install the wheel on
the direction of nose fuselage.

Add.:FeiYi Building,face to Labor Bureau, Fumin Middle Road, Dalang Town,
Dongguan City，Guangdong Province, China
HK Freewing Model International Limited
东莞市飞翼电子科技有限公司
香港飞翼模型国际有限公司
地址: 广 东省 东莞 市大 朗镇 富民 中路402-408号飞 翼楼 四楼
Web: http://www.sz-freewing.com
Email:[e-mail]
Tel: [phone] Fax:[phone]
Web: http://www.sz-freewing.com
Email:[e-mail]
Tel: [phone] Fax:[phone]
Dongguan Freewing Electronic Technology Ltd
R