Frigidaire FRA053XT738 Owner's manual

FRIGIDAIRE
iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii__
iii¸/im
Product
ackaging .;,
aormat sounds :L
www,frigJ

This USE & CARE MANUAL provides specific operating instructions for your model. Use the room air conditioner only as
instructed in this USE & CARE MANUAL. These instructions are not meant to cover every possible condition and situation that
may occur. Common sense and caution must be practiced when installing, operating, and maintaining any appliance.
The power supply cord with
this air conditioner contains a current
detection device designed to reduce the risk
of fire.
UPlease refer to the section 'Operation of
Current Device' for details.
For Your Safety
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any
other appliance. Read product labels for flammability and other warnings.
In the event that the power supply cord is Prevent Accidents
damaged, it cannot be repaired, tt must be
replaced with a cord from the product To reduce the risk of fire, electrical shock, or injury to persons when using your air conditionel
manufacturer, followbasicprecautions,includingthefollowing:
° Be sure the electrical service is adequate for the model you have chosen. This information
Avoid fire hazard or electric shock. Do not
use an extension cord or an adaptor plug. Do
not remove any prong from the power cord.
can be found on the serial plate, which is located on the side of the cabinet and behind the
grille.
• If the air conditioner is to be installed in a window, you will probably want to clean both
iiii ii sides of the glass first. If the window is a triple-track type with a screen panel included,
remove the screen completely before installation.
• Be sure the air conditioner has been securely and correctly installed according to the
separate installation instructions provided with this manual. Save this manual and the
installation instructions for possible future use in removing or reinstalling this unit.
•When handling the air conditioner, be careful to avoid cuts from sharp metal fins on front
and rear coils.
DANGER.IAvoid Serious Injury or Death
This air conditioner contains no user-serviceable parts. Always call an authorized Electrolux servicer for repairs.
Do not insert or place fingers or objects into the air discharge area in the front of the unit.
Do not start or stop the air conditioner by unplugging the power cord or turning off the power at the electrical box.
Do not cut or damage the power cord.
If the power cord is damaged, it should only be replaced by an authorized Electrolux servicer.
In the event of a malfunction (sparks, burning smell, etc.), immediately stop the operation, disconnect the power cord, and call an authorized
Electrolux servicer.
• Do not operate the air conditioner with wet hands.
• Do not pull on the power cord.
• Do not drink any water that is drained from the air conditioner.
02009 Electrolux Home Products, Inc. All rights reserved.

o
o
CAUTION. IAvoid Injury or damage to the unit or other property
Provide occasional ventilation during use. Do not direct airflow at fireplaces or other heat related sources as this could cause flare ups or make
units run excessively.
Do not climb on or place objects on outdoor part of the unit.
Do not hang objects off the unit.
Do not place containers with liquids on the unit.
Turn off the air conditioner at the power source when it will not be used for an extended period of time.
Periodically check the condition of the unit's installation accessories for any damage.
Do not apply heavy pressure to the radiator fins of the unit.
Operate the unit with air filter in place.
Do not block or cover the intake grille, discharge area and outlet ports.
Ensure that any electrical/electronic equipment is one yard away from the unit.
Do not use or store flammable gases near the unit.
READ THIS SECTION BEFORE ATTEMPTING TO OPERATE AIR CONDITIONER.
Unit must be upright for one hour prior to operating.
Operation of Current
Device
Plug in & _,
press RESET
The power supply cord contains a current device that senses damage to the power cord. To test
your power supply cord do the following:
1. Plug in the Air Conditioner.
2. The power supply cord will have TWO buttons on the plug head. Press the TEST button. You will
notice a click as the RESETbutton pops out.
3. Press the RESET button, Again you will notice a click as the button engages,
4. The power supply cord is now supplying electricity to the unit,
,Do not use this device to turn the unit on or off.
• Always make sure the RESET button is pushed in for correct operation.
, The power supply cord must be replaced if it fails to reset when either the TEST button is pushed,
or it cannot be reset. A new one can be obtained from the product manufacturer.
•If power supply cord is damaged, it CANNOT be repaired, It MUST be replaced by one obtained
from the product manufacturer.
02009 Electrolux Home Products, Inc. All rights reserved.

Product Registration Record Your Model and Serial Numbers
Record in the space provided below the model and serial numbers. On all models, the
serial plate is located on the outside of the cabinet.
Model No.
Serial No.
Register Your Product
The self-addressed PRODUCT REGISTRATION CARD should be filled in completely,
signed and returned to the Frigidaire Company.
Packaging Remove all packaging from inside the carton, along with any
inserts placed into the side louvers,
\
PACKAGING / INSERTS
LJ
Normal Sounds
Sound of Rushing Air
At the front of the unit, you may
hear the sound of rushing air
being moved by the fan.
High pitched Chatter
Today's high efficiency compressors
may have a high pitched chatter
during the cooling cycle. Vibration
Unit may vibrate and make noise
because of poor wall or window
construction or incorrect installation.
Pinging or Swishing
-- Droplets of water hitting condenser
during normal operation may cause
"pinging or swishing" sounds.
Gurgle/Hiss
"Gurgling or hissing" noise may be heard
due to refrigerant passing through
evaporator during normal operation.
02009 Electrolux Home Products, Inc. All rights reserved.

Air Conditioner Features ELECTRONIC CONTROL
Before you begin, thoroughly familiarize yourself with the control panel and remote
as shown below and all its functions, then follow the symbol for the functions you
desire. The unit can be controlled by the touch pad alone or with the remote.
REMOTE CONTROL
Battery Size: AAA
Warning: Do not mix old and new batteries. Do not
mix alkaline, standard (cabon-zinc), or rechargeable
(nickel-cadmium) batteries.
Note: This remote control is a universal one for lots
of models. Some features on the remote control may
not be applicable to this model.
AD] USTS |
TEMPERATURE-- 1
OR TIME I
SETS MODE
ACTIVATES
TIMER
A
/
temp/timer
cool
energy saver
fan only
®
auto
hi
lo
DISPLAYS
TEMPERATURE/TIME
_SETSFAN SPEED
TURNS UNIT
ON OR OFF
TOUCH PAD
The following instructions represent the Touch Pad, the same instructions can be used for the Remote Control.
TO TURN UNIT ON: YOU WILL SEE:
temp/timer
cool auto
energy saver hi
fan only lo
Q
DO THIS:
PRESSON/
OFF BUTTON
temp/timer
mcool auto
energy saver mhi
fan only lo
@2009 Electrolux Home Products, Inc. All rights reserved.