FRO­NIUS TransSteel 5000 Syn User manual

/ Perfect Welding / Solar Energy / Perfect Charging
42,0426,0256,EN 003-01092017
TransSteel 3500/5000 Syn
Quick guide to synergic welding
SAFETY
Before working with the device, ensure that you have read and understood all the documents provided in hard copy and online.
This document does not describe all the functions of the device. For a complete description of the device, refer to the Operating Instructions.
2
Setting the filler metal and shielding gas
1. 2. 3.
Standard welding
Fast welding, concentrated arc
Root pass welding, powerful arc
4
Setting the welding power
Sheet thickness
Welding current
Wire speed
select desired parameter
set desired parameter
1
Setting the welding process
The welding power parameters can be
adjusted individually
When setting a welding power parame-
ter, the remaining parameters are set
automatically
MMA welding
5
Adjusting parameters for correction
Arc length correction
Welding voltage
Arc-force dynamic
select desired parameter
set desired parameter
3
Setting the operating mode
2-step mode: for short weld seams,
tacking work
4-step mode: for longer weld seams,
high level of comfort
Special 4-step mode: oers settings for
starting and nal current in addition to
4-step mode
Activating/deactivating the key lock
Operating Instructions:
www.fronius.com/transsteel

MIG/MAG Synergic Setup menu
1. 2.
Parameter:
Gas pre-ow time
Gas post-ow time
Slope (2-step, special 4-step)
Starting current (2-step, special 4-step)
Final current (2-step, special 4-step)
Starting current duration (2-step)
Final current duration (2-step)
Feeder inching speed
Burn-back eect
Length of wire that is fed before the safety cut-out
trips
Spot welding time / interval welding time
Interval pause time
Restore factory setup
2nd menu level
Cooling unit control
Cooling unit monitoring
Country-specic setting
Mains fuse protection
Welding circuit resistance
Welding circuit inductivity
Real Energy Input
Arc length correction display
Operating points
retrieve:
1x
save:
delete:
MIG/MAG Manual Setup menu
2.
1. 2.
Parameters:
Gas pre-ow time
Gas post-ow time
Feeder inching speed
Burn-back eect
Ignition current
Length of wire that is fed before the safety cut-out
trips
Spot welding time / interval welding time
Interval pause time
Restore factory setup
2nd menu level
Cooling unit control
Cooling unit monitoring
Country-specic setting
Mains fuse protection
Welding circuit resistance
Welding circuit inductivity
Real Energy Input
Arc length correction display
MMA Setup menu
1. 2. 2.
Parameters:
HotStart current
Hot current time
Anti-stick
Restore factory setup
2nd menu level
Welding circuit resistance
Welding circuit inductivity
Exiting the Setup menu
Service parameters Parameters: Example of display:
Firmware version
Welding program conguration
Current welding program
Motor current for wire drive in A
Arc time
2nd menu level (Service)