FROG Leap Pool Hibernation User manual

Pool Hibernation
™
Operation Instructions
For Fall Closings
The 1-2 Winterizing Punch!
1. FROG Leap Depth Charge™
removes contaminants
to keep water crystal clear.
2. FROG Leap ALL-OUT™
prevents algae to
prepare the pool for a
smoother spring start-up.
A
L
L
-
O
U
T
KING TECHNOLOGY, INC.
530 11th Avenue South • Hopkins, MN 55343
952-933-6118 • FAX [phone] • www.kingtechnology.com
Before lowering the water level and discard-
ing the used FROG Leap Anti-Bac Mineral
Pac, insert FROG Leap Depth Charge using
steps 1 through 7.
I
N
F
U
Z
E
R
1. With the circulation
system off, set control dial
to 0 and remove the cap to
the FROG Leap or POOL
FROG System.
COLORED
CAPS
2. Remove caps from
FROG Leap Depth Charge
with a pliers or other
suitable tool.
3. Turn FROG Leap Depth
Charge over so open ends
face down and insert into
the center of the FROG
Leap Anti-Bac Mineral Pac.
The ends of the pac will
align with an L-shaped key
in the system. DO NOT
FORCE.
1. FROG Leap Depth Charge
2

7. Replace cap on FROG
Leap or POOL FROG
System and allow circula-
tion to run at least 15 min-
utes before inserting any
other FROG pac products.
I
N
F
U
Z
E
R
4
4. Replace cap on FROG
Leap or POOL FROG
System and set dial to
Setting 5.
5. Turn on pump and allow
1 hour for the product to
slowly dispense into the
pool. If after 1 hour, the pac
still contains some ingredi-
ent, re-insert, replace cap
and run the circulation for
an additional 30 minutes.
All components are recyclable when finished dispensing.
6. Remove the empty
FROG Leap Depth Charge
and discard or recycle.
WE RECYCLE
3
2. FROG Leap ALL-OUT
Wait 24 hours after FROG Leap Depth
Charge to dispense FROG Leap ALL-OUT
algae preventative following steps 1-7:
Ensure a worry free off season as your pool sleeps
away the winter months.
U.S. Patent Numbers: D410,520; 6,210,566; 6,544,415; 6,814,095;
6,948,510 and other U.S. and Foreign patents pending.
553101143N 20-48-0261
3. Insert upside down into
center of FROG Leap Anti-Bac
Mineral Pac pushing down firmly on
key to puncture seal.
1. Turn off pump and turn dial to
Setting 0 and remove cap from the
FROG Leap or POOL FROG System.
2. Remove cap from FROG Leap ALL-
OUT without removing seal.
NOTE: Avoid adding other chemi-
cals until this product has been
circulated (filtered) for at least
24 hours.
9
0
-
D
A
Y
4
4. Replace cap by hand only.
DO NOT OVER TIGHTEN. Turn
control dial to Setting 5.
5. Turn pump on for 90 minutes
allowing FROG Leap ALL-OUT to
circulate through pool.
6. To remove FROG Leap ALL-OUT,
turn pump off, turn dial to 0, remove
system cap.
7. Lift FROG Leap ALL-OUT up and
allow any water in the container to
drain through the system before
recycling or discarding in trash.
NOTE: If water shows more than a
hint of blue inside FROG Leap or
POOL FROG System, replace the cap,
turn dial to Setting 5 and run the
pump for one minute.
7A.If pool size requires additional
FROG Leap ALL-OUT, repeat steps
1-7.