6
Above Ground
POOL SIZE
Gallons Diameter
12 Hour Pump Run Time
Pump Size
1/2 hp 3/4 hp 1 hp 1 1/2 hp
7.000 (18’)
2.0 1.5 0.5 2.5*
9.000 (21’)
2.5 2.0 1.5 3.0*
12.000 (24’)
3.0 2.5 2.0 1.5
15.000
3.5 3.0 2.5 2.0
20.000
4.0 3.5 3.0 2.5
25.000
4.5 4.0 3.5 3.0
For the first week test the pool water daily for
free chlorine with FROG
®
Test Strips to ensure
correct dial setting. Continue to test weekly
throughout the season.
Start-up and Operation
Once you’ve set the dial on the Mineral Infuzer®to ON, set the dial on the Chlorine Infuzer®by matching up the
parameters of your pool on the chart below. THIS IS A STARTING POINT ONLY and may need to be adjusted to fit
your individual pool needs. See #8 below for adjusting directions. IMPORTANT: Pump run times less than 8 hours
could result in under chlorination due to inadequate flow through the system.
7.
8.
9.
5.
6.
After each testing, adjust the dial up by
1/2 increment if the free chlorine reading
has dropped below 0.5 ppm or adjust
down by 1/2 increment if the reading
has risen above 1.0 ppm. Continue this
process each day until the free chlorine
reading stabilizes to at least 0.5 ppm.
Remember to adjust dial by 1/2 increments only in
order to prevent over chlorination which may bleach pool
surfaces.
If using another means of chlorine support -
follow steps 1-4 on page 5 then continue below.
Shock pool every two weeks or as needed
to maintain water quality. Follow label
directions on the shock treatment used.
Set dial on Mineral Infuzer®to ON.
Leave Chlorine Infuzer®empty.
Maintain a minimum chlorine reading
of 0.5 ppm with a chlorine delivery
device or hand feeding.
Shock pool every two weeks or as
needed to maintain water quality.
Follow label directions on the shock
treatment used.
Do not add shock in or near the
skimmer or into either of the FROG
Leap®Twin™ Infuzers® as it could
damage equipment, risk potential
explosion or discolor your pool
surface.
Do not add shock in or near
the skimmer or into either
of the FROG Leap®Twin™
Infuzers®as it could damage
equipment, risk potential
explosion or discolor your
pool surface.
Above Ground
POOL SIZE
Gallons Diameter
8 HOUR PUMP RUN TIME 12 HOUR PUMP RUN TIME 24 HOUR PUMP RUN TIME
PUMP SIZE
1/2 hp 3/4 hp 1 hp 1 1/2 hp
PUMP SIZE
1/2 hp 3/4 hp 1 hp 1 1/2 hp
PUMP SIZE
1/2 hp 3/4 hp 1 hp 1 1/2 hp
7.000 (18’) 4.0
3.5 3.0 2.5 2.0 1.5 0.5 2.5* 1.0 0.5 0.5 1.5*
9.000 (21’) 4.5
4.0 3.5 3.0 2.5 2.0 1.5 3.0* 1.5 1.0 0.5 2.0*
12.000 (24’) 5.0
4.5 4.0 3.5 3.0 2.5 2.0 1.5 2.0 1.5 1.0 2.5*
15.000 NR
5.0 4.5 4.0 3.5 3.0 2.5 2.0 2.5 2.0 1.5 1.0
20.000 NR
NR 5.0 4.5 4.0 3.5 3.0 2.5 3.0 2.5 2.0 1.5
25.000 NR
NR 5.5 5.0 4.5 4.0 3.5 3.0 3.5 3.0 2.5 2.0
24 HOUR, LOW SPEED PUMP RUN TIME
In order to ensure proper performance when running the pump on
low speed for 24 hours per day or high speed less than 6 hours
per day, bleed the air while the pump is on by unscrewing the cap
knob until water appears. Then screw the knob back on. Repeat
this process each time the cap is removed for any reason. Set the
control dial at 6 and follow the adjustment directions in Step 8 to
determine the correct setting for your pool.
* – Bypass installation recommended. RECOMMENDED FLOW RATE: 20-60 gpm
NR – This pump size is not recommended for this size pool. Most common pool size
Find your starting dial setting by matching up the parameters of your pool on
the above chart. An above ground pool with approximately 12.000 gallons with
a 1 horse pump running 12 hours a day would require a starting setting of 2.0.
