Fujitsu ScanSnap iX500 User manual

ArethemobiledeviceandtheScanSnapiX500connectedtothesame
wirelessLAN?

[Resolution]
MakesurethattheWi‐FiswitchatthebacksideofScanSnapiX500is“ON”andthe
Wi‐Filampatthefrontsideislightingin“blue”.



IftheWi‐Filampislightinginorange,thewirelessaccesspointandScanSnapiX500are
notconnectedproperly.Checkthefollowingitems:

oMakethedistanceshorterbetweentheScanSnapiX500andthewireless
accesspoint.
oChangeanangleofScanSnapiX500.
oIfthereareanyobstacles(wall,metalplate,etc.)and/ornoisesources
(Microwave,cordlesstelephone,wirelessdevices,etc.)betweenScanSnap
iX500andthewirelessaccesspoint,avoidorremovethem.
oConnectScanSnapiX500toacomputerviaUSB,andeitherperformawireless
settingusingtheScanSnapWirelessSetupTool,orfollowthedirectionofthe
wirelessdiagnosisresult.

ClosetheADFpaperchute(cover)ofScanSnapiX500toturnitoff.Then,turnthe
ScanSnapiX500onagain.
Turnon/offthewirelessaccesspointtoresetit.
Checkthenetworksettingofthemobiledevice.IftheScanSnapiX500isnotconnected
tothesamenetworkasthemobiledevice,connecttheScanSnapiX500tothenetwork
thatthemobiledeviceisconnectedto.
Back side

Iftherearemultiplewirelessaccesspoints,makesurethattheScanSnapiX500andthe
mobiledeviceareconnectedtothesamewirelessaccessrouter.

<HowtocheckSSIDsettinginthemobiledevice>
LaunchScanSnapConnectApplicationinyourmobiledevice.Tapthe[Network]icon
underthe[FileList]screen.CheckSSID.IfanSSIDisnottheoneyouwouldliketo
connect,exitthesettingonce.Then,connectthenetworkyouwouldliketoconnect
from[Wi‐Fi]underthe[Settings]ofthemobiledevice.

