Funn FUNNDURO Guide

WWW.FUNNMTB.COM FUNNDURO STEM 2022.09.10 / REV. 0
INSTALLATION AND USE
Thank you for purchasing the FUNN FUNNDURO STEM.
Please read these instructions thoroughly before attempting to install this item.
Following all fitting instructions in order is required for compliance with FUNN’s warranty policy.
FUNNDURO STEM
Remove all bolts. Grease the threads and under the heads.
Ensure the external surface of the steerer tube is both
clean and dry. Slide the stem onto the steerer, depending
on the rise or drop required.
1.
2.
Fit the top cap and tighten the headset pre-load bolt to
remove any play while keeping the steering smoothly.
3.
．Torque wrench
．Funnduro Stem 1 PC
contents
Steerer tube preparation
stem installation
．Funnduro stem requires a 28.6mm (1 1/8”) steerer tube.
．Ensure the steerer tube is the correct length – there should be 2-3mm gap from the top of the spacer or stem
to the top of the steerer tube. If the steerer tube requires modifying to fit, ensure it is cut level.
．Hex key 4mm
tools required
2 to 3mm gap from
top of stem
to top of steerer tube.

WWW.FUNNMTB.COM FUNNDURO STEM 2022.09.10 / REV. 0
1 3
4 2
EVENLY
SPACED
Please check the torque for all the bolts twice a year. Please also inspect the stem and handlebar for damage and visible cracks.
If any damage, please stop using the part. It should be replaced immediately. Failure to do so may result in serious injury.
Warning
6Nm
6Nm
INSTALLATION AND USE
6Nm
Install the handlebar and place the faceplate over the bar. Thread the bolts in evenly, just enough to hold the bars in the
stem.
4.
Adjust the handlebar to the preferred position; then tighten the top clamp bolts to 6Nm.
It is advised to tighten incrementally in a cross pattern to distribute the pressure equally.
5.
FUNNDURO STEM
Insert the steerer clamp bolts. Align the stem to the front wheel and then tighten the stem bolts to 6Nm.
Make sure the stem bolts are tightened before riding. Riding with a loose stem can result in serious accidents.
6.